User manual FAGOR CR-20

[. . . ] The manufacturer shall not be responsible for any damages that may arise from improper or inadequate use, or for repairs conducted by non-qualified personnel. Do not touch the appliance with wet or damp hands or feet. Keep the appliance separate from water or other liquids, to avoid electric shock; do not connect the appliance to the mains if it is on a damp surface. place the appliance on a dry , firm and stable surface. [. . . ] Before using the coffee machine for the first time, wash the filters (15 and 16) the measuring spoon (14), the water reservoir (2) and the steam nozzle (12) with soapy water. The inside of the machine must also be cleaned. To do this, fill the reservoir with water and operate the machine without coffee several times (following the steps in section 6. Once the coffee machine is clean, set the machine on a dry, firm, stable surface. Open the water reservoir lid (1) and fill with fresh, clean water up to the MAX mark. Replace it in the bottom of the coffee maker. Pilot light (7) will start flashing until the machine has warmed up. When the pilot light (7) stops flashing, the machine is at the correct temperature and is ready to make coffee. Warm the cups: Place the cups upside down on the cup warming plate (3). When the machine is hot, the plate (3) will heat the cups (fig. Level, turn the function selector (6) to the position and the flow of coffee will stop. Do not remove the cups until the coffee has completely stopped flowing. WARNING: Do not leave the coffee maker unattended while operating. The filtering process must be stopped manually. The unit must be manually switched off to avoid overflowing, splashing and possible danger or injuries. â· When you have finished using the coffee maker, place the I/0 switch (17) in the "0" position to switch off the machine, then unplug the appliance from the power point. Make sure that the coffee maker is cold before doing any cleaning or maintenance. When the unit is cold, remove the filter holder (9) from the upper filter head (8) and holding the closed part of the filter forwards, empty the used coffee. To make another cup of coffee, repeat the process. Once the coffee machine is ready, select one of the filters (15 or 16), place it in the filter holder (9) and measure the desired quantity of coffee into it (fig. D): - One small coffee: Place one spoon of ground coffee into the filter for small coffee (16) - One large coffee: Place two spoons of ground coffee in the filter for two cups of coffee (15). - Two cups of coffee: Place two spoons of ground coffee in the filter for two cups of coffee (15). [. . . ] Place the steam tube (12) into a container for hot water and turn the function selector (6) to the position. When there is enough hot water, push the hot water button (4) again. move the function selector (6) to the position. When finished making froth, the steam button (5) and hot water (4) indicator lights will begin to flash. [. . . ]