User manual FAGOR DH-22 2006

[. . . ] Do not use the appliance if the cable or plug are damaged. The manufacturer holds no liability for any damages arising from unsuitable or improper use of the appliance or from repairs carried out by non-qualified personnel. IMPORTANT: Never for any reason cover the appliance during operation as this could lead to dangerous overheating. pARTICULARLY: · Important: This appliance must not be used near baths, showers, sinks, etc. [. . . ] Each time this button is pressed the selection will move on to a different setting according to the following sequence: 50% 55% 60% 65% 70% Close the doors and windows of the room in which the appliance is to be used. The temperature in the room in which the appliance is to be used must be between 5ºC and 35ºC. if the temperature exceeds these limits the compressor will stop working. If the ambient temperature is lower than 5º C, the absolute humidity will be very low and it will therefore not be necessary to use the dehumidifier. When the appliance stops, wait around 5 minutes before starting it up again. Do not place any objects or pour any liquids into the water tank. Each time this button is pressed the selection will move on to a different setting according to the following sequence: FUNCTIONS a) The appliance will dehumidify the air when the ambient humidity is higher than 54% RH. If the ambient humidity is lower than this, the appliance will only clean the air. INDICATORS e) When the tank is full, this indicator will flash, three beeps will sound and the dehumidifier will switch off. f) If this indication appears on the display , the dehumidifier is on defrost function. The user does not need to regulate this function, as the appliance will automatically go on to dehumidification after a few minutes. The compressor will switch off, the fan will continue to function, and the indicator will remain on. The dehumidifier is supplied with the following parameters selected by default: If you wish to change the selection, proceed as follows: (3) Select the fan speed with button 6. : (high speed) (low speed) (4) You may select a determined time interval using the timer (6. (6) If you have chosen the SETTING, function, choose the desired relative humidity using the button. For example: if you select 70%, this means the air will be dehumidified until it reaches a percentage of 70%. The appliance will automatically switch off if the humidity is lower than 70% (the compressor will switch off, but the fan will continue functioning). Will take place if you have selected 50%, 55%, 60% or 65% humidity. Caution: If the "Defrost" function appears when the appliance is switched on and it is not possible to select another function, switch the unit off by pressing the on/off button and unplug the device. Unplug the appliance before carrying out any maintenance or cleaning. Clean the outside of the appliance with a soft damp cloth. Do not use water, solvents or similar substances to clean the appliance. [. . . ] Otherwise, you will be responsible for all expenses given rise to, even during the guarantee period. Have you selected a degree of humidity higher than the ambient humidity?The appliance does not reach the degree of humidity set even after it has been working for a long time · Are you opening the doors or windows too often?The appliance blocks on "Defrost" as soon as it starts up · Turn the device off by pressing the on/off button and unplug it. [. . . ]