User manual FAGOR LAVEUR FG879

[. . . ] EN ROBOT VACUUM CLEANER 3 IN 1 FG497 Please read this instruction carefully before using Please comply with the safety precautions below This safety precaution is aimed to avoid personal injury and property damage, please read the following terms carefully. The following symbols indicate meanings as below: Caution Violation might cause caution personal in jury Attention Attention violation might cause machinery damage Caution No one else can disassemble, maintain or transform the product except the maintenance designated by our company. Or it may cause fire, electric shock or personal Don't use other charger but the equipped one of the robot, or it may cause product damage, electric shock or fire due to high voltage. Don't touch high-voltage power cord of the electric appliance with wet hand, or it may cause electric shock. [. . . ] Then use “▲▼” buttons to choose from 1-7 and reserve and set week. After existed, aim the remote control to robot and press "appt" button to input reservation data into robot. Reservation setted successfully after received voice response. During the standby or operating status of robot, press this button to start search and connect charging stock for self-charging, and press it again to stop charging. "SPEED" button: Adjust speed with this button according to the room space and personal habit. Robot walks and cleans forward after pressed this button, and stop automatically if there is obstacle or stair in front. Press this button once, robot walks backward for a certain distance and stop. Press this button once, robot turns left a little and stop. Press this button once, robot turns right a little and stop. Week setting Reservation time and week setting speed Forward ▲button Backward ▼button Turn left ◀ button Turn right ▶ button Attention: 1. Do not press two or more buttons of remote control at the same time. The remote control distance is with 5m from robot, and also depends on different working environment. Voice function Voice prompt instruction Operation Switch on power switch of robot Press "AUTO" button of keyboard or remote control Press "SPEED" button of keyboard or remote control Press "DOCK" button of keyboard or remote control, or when the battery is low Press “APPT” button on remote control After the robot plugged with adapter or connected with charging dock When the side brush motor is over-current When the middle brush motor is over-current When the left wheel motor is over-current When the right wheel motor is over-current Voice prompt Hello, boss!First press: clean quickly; Second press: clean normally. Setting of space isolator Space isolator builds a locked area by sending out infrared signal, so as to prevent the robot entering unnecessary area. short distance signal sender ON/OFF switch Power indicator Horizontal signal sender P2-3 P2-4 01. Please install battery before using the Isolator, refer to P2-4. Open the bottom cover of isolator and insert. Of 1# battery according to the polarity. Make sure the polarity with no mistake, or it may damage the Isolator. ON means sending infrared signal normally, while OFF means closing space Isolator. The power indicator lighting in green while the space isolator is working, and extinguished with low battery. [. . . ] Clean the scrap and dirt with cleaning brush, refer to P3-15. Spin the main brush gently to take out hairs and wires. Clean the sensor with cotton swab and soft cloth. Wall detection sensor is in the front of robot, while ground detection sensor is at the bottom of robot, refer to P3-16. [. . . ]