User manual FAGOR LF73DWITU

[. . . ] Manual de instalacin y uso del aparato Manual de instalao e utilizao do aparelho Installation manual and instructions for use Installations- und Bedienungsanleitung NDICE / NDICE / TABLE OF CONTENT / INHALT ESPAOL INSTALACIN Y MONTAJE USO DEL APARATO Y CONSEJOS PRCTICOS MANTENIMIENTO Y LIMPIEZA DEL APARATO LOCALIZACIN y SOLUCIN DE PROBLEMAS ESQUEMAS Y MEDIDAS DE INSTALACIN 3 9 21 23 99 PORTUGUS INSTALAO E MONTAGEM UTILIZAO DO APARELHO E CONSELHOS PRTICOS MANUTENO E LIMPEZA DO APARELHO LOCALIZAO E SOLUO DE PROBLEMAS ESQUEMAS E DIMENSES DE INSTALAO 27 33 45 47 99 ENGLISH INSTALLATION AND FITTING USING THE APPLIANCE - A FEW PRACTICAL TIPS APPLIANCE MAINTENANCE AND CLEANING TROUBLESHOOTING INSTALLATION MEASUREMENTS AND DIAGRAMAN 51 57 69 71 99 DEUTSCH INSTALLATION UND MONTAGE BENUTZUNG DES GERTS UND PRAKTISCHE RATSCHLGE INSTANDHALTUNG UND REINIGUNG DES GERTS FEHLERSUCHE UND PROBLEML SUNG PLNE UND MANAHMEN ZUR INSTALLATION 75 81 93 95 99 DISHWASHER INSTALLATION AND FITTING 1 UNPACKAGING THE DISHWASHER UNPACKAGING Remove the internal protection: polystyrene wedges for holding the racks firm. 2 a CONNECTION TO THE PLUMBING The water connection pipe is located on the back of the dishwasher: Connect the pipe to the water inlet, tighten the connection nut and make sure it is securely connected to the appliance. a 51 b The hose must run between the wall and the bottom space at the back of the dishwasher (b1) so that it is not squashed or overstretched. b1 b2 There should be a fixed water outlet drain at a distance of between 25 and 100 cm from the floor. Make sure that the outlet pipe is not too rigid, bent or squashed. max. 25 cm If your dishwasher has a hot water inlet, connect the pipe to the hot water tap. In this case, the maximum temperature must not exceed 60. . . C. [. . . ] In compliance with the EN-50242 standard, the economy wash programme takes longer than the other programmes; however, it consumes less energy and is more environment-friendly. A 3-send continuous beep and a light indicate the end of the programme. *** The Express programme requires powder or liquid detergent, which dissolves easier. English 4 SELECTING ADDITIONAL FUNCTIONS Wash functions must always be selected after the wash programme has been selected. If the programme is changed during the selection, the previously selected functions are cancelled. These functions make it possible to adjust the wash load, times and consumption to a maximum. The additional functions available depend on the model: Button: Time delay This makes it possible to delay the start of the wash programme. Some models can delay the wash 3, 6 or 9 hours. In this case, when you press the time delay button, a pilot light comes on to indicate the chosen option. On other models, it is possible to select the time you wish to delay the wash from 1 to 19 hours, at hourly intervals. On these models, when you press the time delay button, the display shows the number of hours you wish to delay the start of the wash. Button: Top/bottom load (Duo-Zone) Only half the dishwasher capacity is used. Top load, in the top rack, for more delicate utensils, and Bottom load, in the bottom rack, for saucepans or very dirty utensils. Valid for all programmes. Button: Half-load This washes half a load in the top rack only. Valid for all programmes. IMPORTANTE If you change the programme or press the ON/OFF button while selecting the additional functions, all the functions selected are cancelled. 5 START-UP When you have selected the wash programme and the additional functions, close the dishwasher door and it will start up automatically. When the dishwasher is in operation and - You wish to put another utensil in the dishwasher. - You wish to change the wash programme. Put the utensil in the dishwasher and/or change the wash programme. NOTE: For safety reasons the programme will restart after a few seconds. Unless the change affects the duration of the wash programme or involves the time delay option. In this case, press the ON/OFF button ( ) to make any changes. PROG 67 6 END OF PROGRAMME When the dishwasher programme ends, a continuous beep will sound for 3 seconds. When you open the dishwasher door you will be able to see that washing has finished as a pilot light will have lit up on the design panel. 00 MODELS DISPLAY The dishwaser must always be switched off by pressing the OFF button. 7 POWER CUTS minimum memory of 12 hours, depending on model type). After a power cut, the dishwasher continues to work as normal from where it stopped (it has a 8 a b BASIC TIPS There a few things you should always bear in mind. If you do, your dishwasher will last longer and be more efficient. Fill the dishwasher: Try to make the most of your dishwasher s capacity. [. . . ] -- The food remains on the utensils were too old and dry. The utensils come out white This may be because: -- There was not enough detergent or rinse-aid. -- The salt container lid is not closed correctly. -- The salt container has no water or salt. [. . . ]