User manual FAGOR LFA086XL

[. . . ] To use this dishwasher correctly and safely, please read this manual carefully. The manual is divided into sections giving you a step-by-step guide to all your appliance's functions. The text is easy to understand and is complete with detailed illustrations. This user-friendly manual will provide answers to all your questions of the use of the dishwasher. [. . . ] Switch off the dishwasher, switch it back on again, program a new cycle and press start. if the problem persists , contact the technical assistance center. Water intake malfunction The appliance does not take in water or does so incorrectly. Make sure the water connections are correct, that the water supply tap is open and that the filter is not clogged. DESCRIPTION Water pump-out malfunction The appliance does not pump out the water or does so incorrectly. Make sure the drain hose is not kinked or crushed and that the siphon and filters are not clogged. Switch it back on again, program a new cycle and press start. Switch it back on again, program a new cycle and press start. Alarm E7 is displayed at the end of the cycle which, however, is completed given that it does not jeopardize the operation of the dishwasher. to "reset" an alarm: · Open or close the door, or switch the appliance on and back off again. At this point, the dishwasher can be programmed again. Bear in mind the following warnings when installing and hooking up the dishwasher. Once the dishwasher has been correctly installed, prepare for use as follows: · The amount of scale contained in the water (water hardness index) can cause whitish staining on the dry dishes, which tend to become dull over time. The dishwasher is equipped with an automatic softening system which uses a special regenerating salt to reduce the hardness of the water. The dishwasher is factory set for water hardness level 3 (average hardness 41-60°dF ­ 24-31°dH / 23. When using water of medium hardness, the regenerating salt container should be refilled after approximately 20 washing cycles. Some models are equipped with an optical no-salt indicator. In these models, the cap of the salt container contains a green float which descends as the salt concentration in the water drops. When the green float can no longer be seen, the container must be topped up with regenerating salt. the container is situated at the bottom of the dishwasher. After removing the lower rack, unscrew the salt container cap (ref. 8-01) by turning it counter clockwise and pour in the salt using the funnel (ref. [. . . ] Then remount the lower spray arm into its seat and push it down slightly until it click into place (see fig. 9-04) and, if necessary, clean it under running water (at room temperature), using a stiff brush. to remove the filter , grip the tabs , turn counter clockwise and lift upwards; · Push the center filter (ref. 9-05) from the underside to remove it from the micro-filter; · Separate the two parts which make up the plastic center filter by pressing the body of the filter in the zone shown by the arrows (ref. [. . . ]