User manual FAGOR MCP-45

[. . . ] If in need of repair seek assistance only from an After Sales Support service recommended by the manufacturer. You may use the hair cutter while it is plugged in. ⷠThehaircuttermustnotbeusedinthe bathroom if it is directly connected to the mains via the adapter, as this is not a water safety system of any kind. ⷠThehaircuttermaybeusedinthe bathroom if it is not plugged in. [. . . ] Place a towel around the neck of the person whose hair you are going to cut. Seat the person so that their head is at eye level, so you can see better and work more comfortably. If necessary, use books or cushions to raise the person to eye height. First comb the hair, removing knots or ties. Then hold the clippers in the most comfortable manner possible. Relax and work with precision, making short"passes". Donotcutthesideor the rear of the hair in a straight line; work gradually over the entire head. It is best to remove a small amount each time. Before starting, and when working, comb hair regularly in the desired hairstyle. Start cutting When working with the hair clipper for the first time, cut just a small part of the hair until you become familiar with the amount of hair that is cut with a particular setting. After combing hair in the direction of natural hair growth, proceed as follows to achieve a fluid gradual haircut: Step 1. The neck section Use the spacer comb (A), hold the hair clipper with the cutting edge facing upwards and start cutting at the middle, at the bottom of the neck. Press the hair clipper lightly against the head with the teeth of the comb accessory facing upwards. Gradually move the hair clipper upwards, work upwards and outwards through the hair, removing only a small amount each time. Whilst working, gradually move the head of the hair clipper towards you. Then cut the rear section from the start of the neck to above the ears. Rear of head Use the spacer comb to cut the rear of the head. Side of head Use spacer comb short settings (A) to cut Before starting to cut: Take hold of the device whilst unplugged and adjust the spacer comb (A) as desired, changing according to the cut required. When a different length is required, simply unlock the spacer comb (A) by pressing the clip (B) and slide it to the point desired by moving the spacer comb either upwards or The sides ­ the hair directly above the ears. Then set the spacer comb (A) to a longer length and continue cutting the top of the head. Top of head Use the spacer comb (A) to cut the hair on the top of the head from the back to the front, against the direction of the hair growth. In some cases you may have to work backwards from the front. [. . . ] Stopcuttingeverynowandthen, clean cut hair with the comb and check how it looks so far. Afteruse, disconnectthepowercable, extract the comb (A) and clean hair remains from the clipper with the brush. MCP-45: For an optimum cut, it is important that you lubricate the set of blades frequently with machine lube oil (Fig. To preserve the environment, do not discard with domestic refuse when the device is at the end of its life. [. . . ]