User manual FAGOR MH-26

[. . . ] 2 - Never Use your Appliance for Warming or Heating the Room. 3 - Do Not Leave Children Alone - Children should not be left alone or unattended in an area where appliance is in use. They should never be allowed to sit or stand on any part of the appliance. 4 - Wear Proper Apparel - Loose-fitting or hanging garments should never be worn while using the appliance. [. . . ] The red and the black wire from the unit are to be connected to the service ("hot") wires, and the green wire is to be connected to the ground conductor. The circuit protector for the unit should be properly marked inside electric panel and anybody using the unit, or technician servicing the unit, should be advised of circuit protector's location, so that the power to the unit can be disconnected when necessary. Once the unit is properly fitted and connected to the electrical power supply, turn the unit on to ensure that all elements and controls are operating well. Note that your unit is designed for a stabile and steady 240 V supply and the manufacturer, its distributors and dealers cannot be held 8 ·240 V Connect the 3 wires as per the following colour code Green Red Black Phase 2 Phase 1 L L responsible for any unit malfunction due to an inadequate electrical supply (inadequate cable size, low voltage, power surge etc). Furthermore, if your residence has only a 208 V supply system, and if the voltage frequently fluctuates, your cooktop may not function properly It is recommended that the connection to electrical supply is done by a qualified electrician. If there is any visible physical damage on the conduit and the wires, the unit must not be connected to the mains. A qualified electrician or approved service agent should be called in to replace the wires and the conduit. Earth Safety Precautions - Read before operating your cooktop Your induction-cooking unit has been designed for residential use and food preparation, and all of the safety parameters have been rectified accordingly. The unit incorporates numerous safety devices and controls, and a few devices will be mentioned here. - A number of sensors monitor temperature of internal components. If any of these sensors senses that the component temperature is above the limit, the power output of the unit will automatically be reduced, allowing the component to cool down. Once this is achieved, the unit will continue to operate normally at the output level set initially by the operator. 10 Glass Top, Coil Size and Controls 16 cm(6" 1/2) 50 W à 2200 W 22 cm (9") 50 W à 2800 W 28 cm 50 W à 3600 W Cooking zone Control zone 22 cm (9") 50 W à 2800 W 16 cm (6" 1/2) 50 W à 2200 W · DESCRIPTION OF THE CONTROL · POWERING ON PANEL Press the start/stop touch control for the zone you want to use. A flashing "0" indicates that the zone is on. You can then choose the desired power level. If you do not select a power level, the cooking zone will automatically shut off. A B D · ADJUSTING THE POWER Press the + or - power touch controls. Touch Display 6 10 12 Setting Use A Start/stop touch control. D Power pre-select touch controls. medium low heat high moderate heat Maximum maximum For simultaneous use, favour the use of cooking zones located on opposite sides of the hob. On the same side, the use of a cooking zone at maximum power results in an automatic limitation of the other cooking zone on that side, which is indicated in the power level display. 11 Tip · WHICH COOKING ZONE SHOULD YOU USE BASED ON YOUR COOKWARE? · POWER SHARING Under the pretense that only one zone is used with an adequate utensil covering the whole surface of the coil, and that power on the zone is adjusted to the maximum (`12'): - the maximum power output of 22 cm (9") heating zone is 2. 8 kW; - the maximum power output of 16 cm (6 1/2") heating zone is 2. 2 kW. If only one coil is employed, it can be utilized at its maximum power, but as soon as the other coil is turned on, the controls adjust the power on both coils automatically for `power sharing'. This power sharing is administered by unit's microprocessors, which will alternate power between the two elements. There are two factors affecting improved power sharing on your cooktops. The first is the application of an improved technology for power sharing - not using common relays, but rather semiconductors which makes power sharing quicker, thus more efficient. [. . . ] - Avoid storing solid and heavy items in the cabinets above your cooktop. They may unintentionally drop and damage the glass. To Do or Not To Do Do not connect any appliances to the plugs above or near to the induction cooktop; connection cable insulation can melt if in contact with heat, and this may result in an injury and a property damage. Your cooktop must never be used as a storage space or surface for piling up of any material. 14 3 / DAILY CARE OF YOUR APPLIANCE · MAINTAINING YOUR APPLIANCE Cleaning of an induction cooktop is easy. [. . . ]