User manual FAGOR NC-2500

[. . . ] Turn the radiator upsidedown on a rug or a soft surface in order to prevent damaging the paint finish. Use the 2 screws supplied with the appliance to fasten the feet in position (fig. Fit the wheels to the spindles on the feet and push firmly until they click into position. Serie NC (See rating label) Remove the feet and the castors from the polystyrene packing. [. . . ] Adjusting the thermostat The switch and thermostat should be maintained until the desired room temperature has been reached. Now move the thermostat back gradually until the red pilot lamps go out. The thermostat can then remain at this setting. As soon as the room temperature has dropped below the set temperature, the heater switches itself on automatically until the set temperature has again been reached. In this way the room temperature remains constant with the most economical use of electricity. The appliance will maintain a minimum room temperature of approximately 5°C thus preventing freezing with a minimum energy consumption. C) Models with a 24 hour time-clock (fig. 9) To set the heating periods proceed in the following manner: - Check the time by your watch. Turn the numbered dial of the time-clock in a clockwise direction until the number 10 coincides with the reference mark on the time-clock. Set the time period during which you wish the appliance to work by pushing the notches towards the centre. Each notch corresponds to a period of 15 minutes. At this point sections will be visible corresponding to the working periods. Set in this way the radiator will function automatically every day during the set period. (Important: the plug must remain connected to power supply). - To change the programmed time period, just bring back the black notches to their original position and set the new working periods required. Without programmed working periods push all the notches towards the centre. In this case, to turn the appliance off totally the plug must be pulled out apart from switching off, so as to avoid unnecessary working of the timer. Your oil filled raditor is absolutely free from maintenance, fully reliable and will give many years of trouble free service. [. . . ] ⷠDo not use this appliance in rooms having a floor area of less than 4 m2. Do not rest the cable on the appliance while still hot. The appliance is fitted with a safety device which will switch off it in case of accidental overheating. To reset, disconnect the plug from the power for 30 minutes, remove the cause of overheating then plug the appliance in again. [. . . ]