User manual FAGOR PL-2450 E

[. . . ] Do not leave the appliance unattended when it is turned on because it can be dangerous. When removing the plug never pull on the cable. unplug the appliance before cleaning or maintenance. In the event of fault or malfunction where the appliance is not to be used, turn off the appliance and do not attempt to repair. [. . . ] The plug of the supply cord must be removed from the socket-outlet before the water reservoir is filled with water This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance. The LCD display (4) will light up for a second, and a beep will sound when it switches off. Change the temperature with the screen settings: press the "increase temperature" regulator (6) to raise the temperature from 1 to 3 and to Maximum. To select the right temperature for each item to be ironed, select the correct point and the correct item, which will appear on the LCD screen while you move from one point to the next. Pour the water into the reservoir hole using a glass (Fig. Do not put any cleaning products or solvents into the water reservoir. â· Check that the water does not exceed the maximum level and replace the cover (8). : If the water in the area where you live is too hard (>27oF), we recommend that you use distilled water. Do not use battery water or water with added starch, perfume, conditioner, etc. The symbol will appear and the "" symbol will flash when the temperature changes from lower to higher and the "" symbol will flash when you change from higher to lower. When the sole reaches the right temperature, you will hear a beeping sound and the " " symbol will come on. The LCD display (4) will light up for a second, and a beep will sound when it switches off. The display will then show "ACRYL" and the iron will start to heat up. When you hear the beep and the " " symbol appears, the iron is hot and ready to use. If you want to disconnect the iron, hold the "increase temperature" setting (6) down for 2 seconds (Fig. The spray function is also useful to dampen creases created by accident while ironing. : It may be necessary to press the spray button several times to activate this function. When the iron has reached the temperature selected, press the extra steam button (3) while ironing and the steam will come through the holes in the sole (Fig. F) onto the fabric, smoothing out the most difficult creases. Wait for at least 5 seconds between each use of the extra steam button so as to allow the iron to heat up again and thereby obtain the maximum amount of extra steam. upright steam: The extra steam function also works when the iron is in an upright position. To use this function, hold the iron upright around 15-30 cm away from the item, press the extra steam button (3), and the steam will come out of the holes in the sole (Fig. [. . . ] Clean the outside and the sole with a damp cloth. do not use detergent or abrasive products. Do not immerse the iron in water or run it under the tap. self-clean This function will remove limescale and minerals accumulating in the steam chamber. [. . . ]