User manual FAGOR PLC-804

[. . . ] Should repairs be needed, consult only authorised Technical Support Services and request that original spare parts be used. If there is no compliance with the above, the appliance's safety will be put in danger. Should the cable get damaged or need replacing, contact only Technical Support Services authorised by the manufacturer. Prevent the cable from touching the hot parts of the appliance or hot surfaces. [. . . ] Do not let them use the appliances without supervision. The user must not leave the iron unattended while it is connected to the supply. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a similarly qualified person in order to avoid a hazard. The plug of the supply cord must be removed from the socket-outlet before the water reservoir is filled with water The filling aperture must not be opened during use. Instructions for the safe refilling of the water reservoir shall be given. WARNING: For your own safety, when you want to iron using steam, before starting to iron, it is necessary to wait until the steam indicator (4) lights up. In the event that this indicator should not light up, do not use the product and contact an authorised after-sales service centre. Wait until the appliance cools down completely. Fill the boiler up to the MAX level using the funnel (11). Remove all of the protective film or labels from the shoe and boiler if there are any. Plug the appliance into a suitable power point. Adjust the "steam level" to the maximum level by turning the steamlevel control (5). Turn the iron's temperature control (9) in a clockwise direction until the maximum The pilot light (6)will light up. The "steam ready" LED indicator (4) will light up when it is ready for steam ironing. The pilot light will turn off when the iron reaches the desired temperature. The first time, begin to iron using an old towel. wARNING: To avoid burns or accidental falls caused by the tube , the appliance has some holders for hooking the cable. These holders are inserted into their respective holes, as shown in figure3. Fill the boiler with tap water (refer to the "Filling the Boiler" section). Plug the appliance into a suitable power point. The "steam ready" LED indicator will light up when it is ready for steam ironing. The pilot light turns off when the iron has reached the desired temperature. [. . . ] For further information, contact your local authority or the shop where you bought the product. Unplug the appliance and wait until it cools down before proceeding to clean it. â· Clean the outside of the boiler with a soft, slightly-dampened cloth. Cotton deposits and other impurities can attack the iron's shoe. [. . . ]