User manual FAGOR PLV-125

[. . . ] Otherwise, the appliance could be irreparably damaged. Prior to using this appliance for the first time, read this instruction booklet carefully and keep it in a safe place for future reference. Only then will you get the best results and maximum level of safety during usage. Before using the appliance, check that the voltage of your home mains matches that given on the appliance. [. . . ] Only leave it plugged in when necessary. When you decide to get rid of the appliance once and for all, you are advised to unplug it and prevent it from being used again by, for example, cutting the power cable. When the LED indicator (9) switches off, the iron has reached the selected temperature. This LED indicator will light up and switch off during ironing indicating the thermostat's cycles. Bear in mind that if you lower the temperature, the LED light (9) will remain off until the soleplate (13) has come down to the selected temperature and, at that moment, it will light up again. Press the spray button (5) to dampen the garment as this makes dry ironing easier. When you have finished, turn the temperature selector to the MIN position and unplug the iron. Let it cool down before proceeding to clean it on the outside and put it away. Warning: For dry ironing, make sure that the steam regulator is always in the dry ironing position. Remove the stickers or protective covering from the soleplate and casing Unroll and straighten out the mains cable. Follow the instructions in the "Selfcleaning" section of part "9 CLEANING AND MAINTENANCE" to make the iron ready for use. Slowly pour the water through the opening for water (3) with the help of a glass (Fig. Do not pour any cleaning product or solvent into the water tank (12). Check that the water does not go beyond the maximum filling level. After ironing, empty the water tank (12). Note: If the water in your area is too hard ( >27ºF ) we recommend using distilled water. Before ironing with steam, check that the fabric is suitable for this type of ironing. Fill the tank with water (refer to section 6, "Filling the Tank"). If the selected temperature is too low, water may drip from the soleplate. When the LED indicator switches off, the iron has reached the selected temperature. This LED indicator (9) will light up and switch off at regular intervals during ironing. If you lower the temperature, the LED indicator (9) will remain off until the soleplate has come down to the selected temperature and, at that moment, it will light up again. [. . . ] Wait until the LED indicator (9) switches off then on two or three times to make sure that the established temperature has been reached. The dirt will come out of the opening, together with the steam. Move the iron over a damp cloth to clean the soleplate. Let the iron cool down before putting it away. [. . . ]