User manual FAGOR TK-500

[. . . ] ⷠNever fill the kettle to above the `MAX' mark, or else the water may overflow when it begins to boil. ⷠNever switch the kettle on when the water is below the indicated `MIN' level. This product generates heat and steam at a high temperature which will escape immediately once the lid is opened. CAUTION: Do not use the product on a sloping surface; do not use it unless the element is totally covered in (The appliance has a total of 13 temperature adjustments, from 40ºC to 100ºC, increasing or decreasing by five degrees). [. . . ] Then press the button, the screen will flash continuously and the kettle will go into water boiling mode. If you press again, the LED screen will displayed nothing, the kettle will return to standby mode. ⷠOtherwise, ifinthefirstinstanceyou press and then the "+" or "-" button to select the desired temperature, the kettle will go into water boiling mode. If you only press the button, the appliance will reach the Otherwise, if the temperature is lower, the element will not function. whilethekettleisheatingthewater , the digits on the screen will flash. When the temperature of the water to be boiled reaches the preselected temperature, these digits will stop flashing. The kettle will count two minutes and then go into standby mode. You can do this yourself by pressing before these two minutes pass. When the water inside reaches boiling point. Do not add more water to the kettle while it is switched on. This appliance also has a function for keeping the water hot. Once you have turned on the kettle, you can select the temperature you wish with the "+" or "-" buttons. Then press the 'button and then press . The kettle will start the process of keeping the water hot, and this process will continue for a maximum period of one hour. As the process continues, the screen will show a dot at the bottom right. During the keep hot process, if you press the ` ' button, it will come out of the keep hot function and return to the water boiling mode. When the kettle goes into the keep hot mode, the circuit begins to count the time, and after one hour nothing will be displayed on the screen; the kettle will return to standby mode. During the onehour period, if you press the button, nothing will be displayed on the screen and the kettle will return to standby mode. The kettle is fitted with an automatic safety protection device in case of overheating and for when there is no water in the kettle. It is activated if the kettle is turned on when there is not enough water inside, i. When the water level is below the MIN mark. If this happens, switch the kettle off at the mains and unplug the cable. [. . . ] If you prefer, you can also decalcify your kettle with white vinegar. to do so , follow the instructions outlined below: · Placethreecupsofvinegarinthe kettle and then fill with water. The next morning, pour away the watervinegar mixture, fill the kettle with fresh water and then empty once again. We recommend that you decalcify your kettle once every 4 weeks if used on a daily basis. [. . . ]