User manual FAGOR VFA-78 S

[. . . ] Consult this plate before proceeding with electrical connection. â· Electrical connection must be carried out by a certified specialist familiar with official regulations. â· If your appliance has halogen hotplates avoid, looking directly at them when they are not covered by a cooking pan. Fill in the data table below with all the data of the cooktop that appear on its label. [. . . ] Once these steps have been carried out the setting sequence of the heat source timer ends. If between each step there is a pause of over 10 seconds or if you do not choose a length of time, the timer will automatically switch itself off Once the timer has been set to a heat source and the time has been chosen, the timer will gradually count down the time and will indicate the time remaining to switch off the heat source. During the timing, in the heat source display you can see the selected power and the (indicating that this heat source is timed) alternatively. Once the time has passed the heat source will switch itself off, the control will release a warning acoustic signal and will flash in the timing display. Touch any sensor control to stop the warning signal. Sensors The radiant cooking surface is fitted with sensors that are touch-sensitive and also react to the presence of a reflective object. the hotplate is operated by touching the corresponding sensors with your finger. Take care to touch only one sensor at a time, otherwise they will not react to the touch. Keep the sensors clean and do not place objects on them. the sensors may misinterpret dirt or objects placed on them. While the cooking surface is off, the indicators for all sensors are also switched off. starting up Touch the ON/OFF sensor for 3 seconds. If no power is selected within five seconds, the hotplate will automatically switch off and must be switched on again. Power selection - / + Each heater has - / + power sensors. Touching these allows the power to be set in the cooking ranges of 1 to 9. To alter the power while the hotplate is on, touch - / + sensors to obtain the required power level. Switching off the heat source Choose 0 power for the heat source when you wish to turn off. if the hotplate is hot , H will light up indicating the hotplate is still hot. Residual heat display H When activated but with level 0, the corresponding displays shows 0 and H alternatively. While a hotplate is still hot but switched off, the display will show H. Depending on the power that was used, this display may remain on for up to approximately 30 minutes. Do not touch the hotplate or its surrounding area , white "H" is displayed. [. . . ] Clean the radiant glass surface frequently, when it is cool. Once a week, clean thoroughly with specific products that preserve and protect radiant cooktops hobs. Scrape off stuck on stuck dirt with a scraper If sugar (or sugary matter) or plastic is accidentally burnt on the cooktop, remove at once with the scraper while still hot. Otherwise it may leave a permanent mark. [. . . ]