User manual FAGOR VFI400R

[. . . ] Aluminium receptacles are not recommended as they can stain the glass of the hob. You have various elements on which to place the receptacles. Choose the most suitable one depending on the size of the receptacle. Press seconds to turn on the hob; the of the different cooking zones will be activated. [. . . ] You have 5 seconds to select the desired level, you are advised to use levels from 3 to 6 (2. After five seconds the rapid heating will be set and and the power will be displayed alternately. Once the maximum temperature has been will disappear, leaving the reached, power constant. Models dfghjklmo: Select an element and set it at the maximum power by pressing until a 9 and a dot are displayed (2. Adjust the power by pressing ; levels 3 to 6 are recommended (2. After 5 seconds, fast heating is set and the power will be displayed followed by a dot (2. To cancel the function, press the key of the programmed element and select a new power. Make sure that the element you are going to activate is the element you want to use (2. Turn the control to the desired position and the `on' light will come on (2. 2) which also indicates the residual heat when the element is turned off. On the models with double elements or a large hotplate, turning the control to the left will adjust a part of the element and turning the control to the right will adjust the whole element (2. Select the power of the element you want to turn off. They can stain the glass, unless they have a stainless steel protective base. The heat elements should not be operated without a receptacle. Make sure that the diameters of the receptacles are larger than or the same as the element to be used and place them in the centre of the heat source. Try not to move the receptacles as this can scratch the glass. Do not apply cold water directly onto the hob when it is hot. caution: Intermittent operation of the cooking zones is not a fault. They operate with longer or shorter on and off periods depending on the desired power. Clean the surface of your hob regularly once it has cooled down. Once a week, clean thoroughly with products specifically designed for vetroceramic hobs. Stubborn stains can be removed with the glass scraper (3. [. . . ] The heat transmission is best when the base of the receptacle and the diameter of the cooking zone are the same size. When you have finished cooking, if you like you can leave the receptacle where it is to make use of the residual heat accumulated. Use a lid whenever you can in order to reduce the heat lost through steam. electrical and electronic appliance waste management. [. . . ]