User manual FALCON CLASSIC 110 CERAMIC

[. . . ] Thank you for buying the Classic Deluxe cooker. It should give you many years' trouble-free cooking if installed and operated correctly. It is, therefore, important that you read this section before you start, particularly if you have not used a ceramic cooker before. This appliance is designed for domestic cooking only. [. . . ] Alternatively, the grill pan can be washed in a dish washer. Before you remove any of the grill parts for cleaning, ensure that they are cool, or use oven gloves. The grill pan can be easily removed for cleaning, as follows: Remove the grill pan support frame by pulling the grill pan forward: Lift the grill pan clear of the support frame. The support frame is held to the side rails by two clips on each side: Cleaning for burned-on spills Be sure that the heat indicator lights are off and that the hob is cool. remove excess burned-on substance with a singleedged razor scraper. Hold the scraper at approximately a 30° angle to the surface and scrape off the burned-on matter: For each side, support the side rail with one hand and with the other hand lift the frame up and out of the side clips: Move the cooker forward to gain access to the sides (see the `Moving your Cooker' section of these instructions). Open the oven door slightly and remove the front panel fixing screws from the door sides (two each side): For safety, push the side rails back into the grill chamber. If you need to remove the side rails to make cleaning the grill chamber easier, you can unhook them from the grill chamber sides and wipe the sides clean with a soft cloth and mild detergent. dO NOT put the side runners in a dishwasher. Once you have finished, hook the side rails back onto the sides of the chamber. To refit the frame, pull the side rails forward and, for each side in turn, support the side rail and press the frame down into the side rails. Carefully lift off the outer door panel. The inside face of the glass panels can now be cleaned - take care not to disturb or wet the door insulation. Please note that the door is triple glazed but that the inner two panels are fixed and should not be separated. After cleaning, carefully refit the outer door panel and replace the side fixing screws. Oven Panels Both the ovens have panels which have been coated with a special enamel that partly cleans itself. This does not stop all marks but helps to reduce the amount of manual cleaning needed. The Cook & Clean panels work better above 200°C. If you do most of your cooking below this temperature, occasionally remove the panels (after removing the shelves), and wipe with a lint free cloth and hot soapy water. The panels should then be dried and replaced and the oven heated at 200°C for about one hour. This will ensure that the Cook & Clean panels are working effectively. Don't use steel wool or any other materials that will scratch the surface. [. . . ] Remove the 2 screws B, lower the upper plate and remove through the slot in the cooker back. Undo the terminal connections, noting their positions. remove the element fixings and withdraw element. Replace the element and re-assemble parts in reverse order. [. . . ]