User manual FALMEC MIRABILIA

[. . . ] It is dangerous to modify or attempt to modify the characteristics of this system. In the event of malfunctions or if repairs are required to the appliance, do not attempt to solve the problems directly. repairs performed by unqualified persons may cause damage. For all repair and other work on the appliance, contact an authorised service/spare parts centre. [. . . ] After 15 minutes the motor returns to the third speed). The function "desired speed" enables to start the motor at the speed that was selected before the hood was last turned off. optional: version with remote control (some versions only). WARNING: Install the hood away from sources of electromagnetic waves, as these could affect the correct operation of the electronic system. The maximum operating distance could be less than 5 metres in case of electromagnetic interference by other equipment. Light pushbutton on remote control: light on/off. ­ and + pushbutton: increase/decrease speed (to start the motor press either the + or the ­ pushbutton). timer pushbutton: see instructions below. Timer and `filter clogged' alarm pushbutton - This function allows the automatic turning off of the hood after running for 15 minutes at the speed previously set (the pushbutton shows a flickering light). - After about 30 hours of running the pushbutton indicates the need for washing the metal filters (the pushbutton shows a solid red light). To disable the alarm press the pushbutton for a few seconds until the red light turns off. Then turn the hood off and on again to check that the alarm has disappeared. A) b) c) At the bottom of the hood there is a dimmer for the adjustment of the ambient lights. Knob dimmer: turn the knob clockwise to increase light intensity and anticlockwise to decrease it. To turn the light off turn the knob anticlockwise till the OFF click. To turn it on, turn the knob clockwise till the ON click. Soft-touch dimmer: keep the button pressed to increase or decrease light intensity. Dimmer with functions integrated in the control panel: with the motor turned off and by holding down the light button on the control panel for a while (2 seconds) you automatically decide on the mode of the light intensity (incandescent light globe). by pressing on + and on ­ you can adjust the intensity of the light. With the motor running, the prolonged pressing of the button down, will turn the atmosphere light on or off. Replace the incandescent light bulb: make sure that the hood is disconnected from the power supply; remove the decorative glass (refer to section O); fit a new light bulb of the same model (max. The two filters located at the ends of the motor can now be easily accessed. [. . . ] the warranty conditions are provided by the distributor. The manufacturer is not liable for any inaccuracies in this booklet resulting from printing or transcription errors. - Block the extension completely to the lattice-work (C) by screwing down the 4 M4 metric screws (V3). 2) only if the upper lattice-work is not used, or in the case of a false ceiling. [. . . ]