User manual FARSTONE RESTOREIT NETWORK 4

[. . . ] RestoreIT Network ® User's Guide Copyright Notice Copyright© 2006 FarStone Technology, Inc. No part of this publication may be copied, transmitted, stored in a retrieval system, or translated into any language in any form or by any means without the expressed written permission of FarStone Technology, Inc. FarStone grants you the right to use one copy of the enclosed software program ("SOFTWARE") on a single computer. If the SOFTWARE is installed on a network, or more than one user can run the SOFTWARE at the same time, you must purchase an additional license for each additional user or computer. [. . . ] Choose Restore page from the function panel in the upper right of the RITN Administrator main interface. All available backup points will be listed in the box (shown below) - 21 - Note: If you have chosen a client, all IBP of the client computer will be listed, including those created from the RITN Administrator, created from RITN Client or those automatically created according to schedule. If you have chosen a group, only those "group backup points" manually created from RITN Administrator will be listed. Select a Backup Point to restore (highlighted in blue) and click Next. You can choose to restore the Drive C: only or the entire hard disk. Some detailed information and possible results of the restoration will be displayed for you to confirm your settings. The restoration requires a restart of the client computer. To avoid unexpected errors, click Notify Now link to send a message to the client about the restoration. (Optional) After you have confirmed your selections, click Restore Now to start the operation. If you choose to restore a client, skip the next step. If you choose to restore a group, you will be prompted to confirm your operation. Note: If there are some offline clients, you will be notified with a message asking if you would like to continue with the online clients. The client computer should be forced to restart and begin the restoration. Once the restoration begins, the client icon should change to working status a progressive status bar in the function panel. 7. Note: The restoration cannot be canceled once it starts. You cannot perform any other operation on the working clients during this process. When restoring a group, the time needed for these computers will be different, depending on the data amount involved with each computer. Whenever a computer finishes restoration the icon of this computer will be changed back to normal status in the RITN Administrator interface. When the restoration finishes, the client computer should automatically restart to Windows. The icon of the computer in the RITN Administrator interface will change back to normal status. Note: If you have chosen to restore a group, the time needed for each computer is different, depending - 22 - on the data amount involved with each one. Whenever a computer finishes restoration, the icon of this computer will be changed back to normal status in the RITN Administrator interface. [. . . ] If the "Software" is an upgrade from other "Software", whether from us or another supplier, you may use or transfer the "Software" only in conjunction with the upgraded "Software", unless you destroy it. If the "Software" is an upgrade from FarStone, you may only use that upgraded "Software" in accordance with this License. Where a database is included with the "Software", you acknowledge that it is licensed only in connection with the use of the "Software" to perform disk creation, and that the database and all data derived there from must be maintained in confidence in accordance with the provisions of Section E of this document. This License does not grant you any rights to distribute or disclose such a database or data contained therein. [. . . ]