User manual FARSTONE TOTALRECOVERY USB KEY

[. . . ] TotalRecovery TM USB Key User's Guide Copyright Notice No part of this publication may be copied, transmitted, stored in a retrieval system or translated into any language in any form or by any means without the expressed written permission of FarStone Technology, Inc. FarStone grants you the right to use one copy of the enclosed software program ("SOFTWARE") on a single computer. If the SOFTWARE is installed on a network, or more than one user can run the SOFTWARE at the same time, you must purchase an additional license for each additional user or computer. Trademark FarStone® is a trademark of FarStone Technology, Inc. Microsoft, Windows® and MS-DOS® are registered trademarks of Microsoft Corporation. [. . . ] Don't select it for fear of information loss on multiple systems or hidden partition. If you selected option a, double click the partition Capacity to be resized from the list. If you selected option b, skip to step 8. When it shows the structure of the destination partition, double click the highlight and modify its size, and click Next to continue. Click Next to begin the restoration process. 2. 2. 2. 3 Perform Universal Restore To restore the system partition or the entire hard drive of a selected client to dissimilar hardware please do as follows: 1. Select a backup image from the list and click Next to continue. If the backup image you want to use is not listed, you will be prompted to search for the image by clicking Browse. Select to restore with Universal Restore, and click Next. Select to restore a single partition or the entire hard drive, and click Next. Select a destination partition or a destination hard drive to be restored from the image file, and click Next. If you choose to restore a single partition, click Yes to launch the restoration process. To restore the entire hard disk, please select a restore option. Select the checkbox to modify the destination partition size. 14 b. Don't select it if you have information on multiple systems If you selected option a, double click the partition Capacity to be resized from the list. If you selected option b, skip to step 9. When it shows the structure of the destination partition, double click the highlight and modify its size, and click Next to continue. Click Next to begin the restoration process. Click Next to complete the process. 2. 2. 3 Clone Tab 2. 2. 3. 1 Clone Drive Clone Drive duplicates one hard drive to another. It eliminates the need to re-install the operating system, drivers and applications, and enables you to upgrade a new hard drive with only a few mouse clicks. To clone a hard drive, please do the following: Tip To use this function; you will need to have at least two hard drives on your computer. The target hard drive should have enough space to store the data of the source hard drive. 1. Select Clone and then click Clone Hard Disk. Select the Source Disk (top pane) and then the Destination Disk (bottom pane). [. . . ] Number 0 is the primary master, 1 is the primary slave, 2 is the secondary primary and 3 is the secondary slave; Y: is the partition ID, generally defined as 0-25, 0 is for the first partition. Folder: is the place storing the boot file (this is not the boot. ini file). If your system is Windows NT/2000, it should be defined as WINNT. If your system is Windows XP, it should be Windows. [. . . ]