User manual FAURE CHM151W

[. . . ] Young children should be supervised to ensure that they do not play with the appliance. mAINTENANCE · Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. Clean and/or replace the Filters after the specified time period. Clean the hood using a damp cloth and a neutral liquid detergent. [. . . ] Draw a horizontal line at 650 mm above the hob. 1 on the wall as shown about 1-2 mm from the ceiling or upper limit aligning the centre (notch) with the vertical reference line. 1 on the wall as shown at X mm below the first bracket (X = height of the upper chimney section supplied), aligning the centre (notch) with the vertical line. Mark a reference point as indicated at 116 mm from the vertical reference line and 330 mm above the horizontal reference line. Repeat this operation on the other side. Insert the two screws 12a (4, 2 x 44, 4) supplied in the hood body fixing holes, leaving a gap of 5-6 mm between the wall and the head of the screw. Before attaching the hood body, tighten the two screws Vr located on the hood body mounting points. DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. Fix the pipe in position using sufficient pipe clamps (not supplied). Put connection 15 into the connection support 7. It can be stopped in advance by pressing any of the touch controls (T) with the exception of T3. The Delay function works according to the following scheme: 1°speed / OFF = 20 minuets 2°speed = 15 minutes 3°speed = 5 minutes When pressed the motor is set to the third speed Touch control unlit Touch control lit Lights off Lights on Touch control lit Touch control lit Flashing touch control Second speed on Delay function on When pressed the motor is set to the intensive speed timed to 5 minutes. At the end of 5 minutes of intensive speed the hood starts again at the speed it was set Touch control lit to previously. In case the hood is set to the intensive speed directly from OFF-state it will then start from the first speed after 5 minutes of intensive speed. Touch control lit Metal grease filters satuWhen pressed for 4 seconds it resets the filter alarm ration alarm. This procedure can be carried out only when the The alarm starts up after motor is stopped. Flashing touch control 100 working hours. The alarm starts up after 200 working hours. Press the F -touch control for at least 4 seconds until the T1 -touch control flashes. They need to be washed every 2 months or even more frequently in case of particularly intensive use of the hood. [. . . ] Remove the filters one by one pushing them towards the back side of the unit and simultaneously pulling downwards. Any kind of bending of the filters has to be avoided when washing them. Before fitting them again into the hood make sure that they are completely dry. When fitting the filters into the hood pay attention that they are mounted in correct position and that the handle faces outwards. [. . . ]