User manual FBII LEGEND-LED

[. . . ] 8 Instant . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Instant-Stay . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Bypass . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Forced Arming . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 14- CODE Key Function key used when entering or changing the User access codes of your system. INSTANT STAY CODE [USER] * # + 6 5 ARMING THE SYSTEM ARMING the system will activate all portions of your Security System. Arming can only be performed if all zones are READY. For example, if a protected door is open the system cannot be armed. SYSTEM READY The system is ready to be armed if the READY indicator light located in the display portion of the keypad is ON. If the system is ready, ARMING can be performed as follows; ARMING PROCEDURE 1. Enter your four digit user code into the keypad: [USER] The ARMED indicator light will now be lit and if you are leaving the home you may exit through a door designated by your installer as an exit/entry zone for a fixed time period known as the exit delay. SYSTEM NOT READY If the system is not ready to be armed the READY indicator will be OFF. The zone indicator lights will display the zones which are currently not ready. The condition of each zone indicator reflects what the status of each zone as follows; ALARM Fast blinking BYPASS Slow blinking low intensity. TROUBLE Slow pulse NOT READY Solid ON In order to make the system ready ready determine which zones are not ready by observing the zone indicator lights. From the zone number you can find out which area of protection is not ready. For example, assume the the zone 3 indicator light is ON. Typically this might mean that a protected door or window is open. 7 >> Once the problems with each zone has been resolved the READY light will appear and the system can be armed. To arm the system in this situation one of the following actions are necessary; - Make the zone(s) ready. Determine which zones are not ready and perform what is necessary to ready the zone(s) (example, close the door or window, etc), or - Bypass the zone(s) not ready. Bypassing should only be performed if the zone cannot be made ready or intentionally will remain not ready. Remember, zones that are bypassed are not protected when the system is armed. STAY The STAY mode is another way to ARM your system while you remain in the location. The STAY mode will deactivate any interior protection zones which means that you will be free to walk throughout your location without activating the alarm system. In order to enter the STAY mode, the system must be READY. STAY PROCEDURE: STAY [USER] Depress the STAY key followed by your user code. After a sucessful STAY arming the ARMED and STAY indicator will be lit. [. . . ] These conditions are initiated through the simultaneous depression of two keys, as shown below; Reset The DURESS signal is meant to disarm the system and transmit an emergency signal to the Central Station indicating that there is a problem. The DURESS capability must be enabled by your installer and can be initiated in one of two methods; - either by entry of user code #16 or - entry of a valid user code with the last digit altered by one. For example, if there is a valid user code of 1234 then duress codes of 1233 or 1232 exist for that user. [LEV] Note: The user information is entered twice for validation purposes. >> USER DEFINITION CAN ONLY BE PERFORMED BY A USER WITH A LEVEL ONE AUTHORITY. [. . . ]