User manual FEDDERS HB30

[. . . ] An arc fault can be potentially hazardous if left undetected. Do not use an extension cord or plug adapter with this unit. Do not operate unit with decorative front or filter removed. Failure to follow these precautions could result in electrical shock, fire or personal injury. [. . . ] Do not block aiflow inside with blinds, curtains, or furniture. Do not block airflow outside with shrubs, enclosures, or other buildings. Replace the two anti-theft screws at the bottom front sides of cabinet. To replace the decorative front, line up the top tabs and sides, and gently press into position. reattach the screws on both sides of the decorative front. Make sure the power cord aligns with the power cord slot on the bottom of the decorative front. Make sure the decorative front is secure before reconnecting the plug and operating the unit. Cut plastic foam seal to width of window and install between upper and lower window sash. Use latex or silicone sealant (not supplied) to fill any minor openings. Unit is designed to operate with approximately 1/2" of water in bottom pan. Close window until it touches behind air conditioner top bar. Use of flashing (driprail) will further prevent water from dripping inside the wall. Wood frame 1" wood screws Cabinet Bottom bar Interior wall Decorative front Minimum 1x6 wood support (nailed or screwed to wood frame) 2" Wood frame 1 1/2" space 1 1/4" space Brick veneer Lintel angle Caulking Flashing (drip rail) Side louvers Wood filler strip The Power Control turns the unit on and off. Shows the set temperature when the unit is in operation and hours when the timer is being set. These buttons are used to raise or lower the set temperature in increments of 1° from 66°F to 88°F. By depressing both buttons at once, the display will toggle between Celsius and Fahrenheit. When the timer is being set, these buttons are used to change the hour setting in increments of 1 from 00 to 24. A green light will indicate which mode is currently being utilized. cool Mode ­ The unit will circulate and cool the air. Heat Mode (Heat Models Only) ­ The unit will circulate and heat the air. Heater Safety Feature- When heater is powered off, low fan will automatically stay on and run for 60 seconds to ensure the removal of residual heat, meanwhile, the Low Fan LED blinks until the low fan stops. Fan Mode ­ The unit will only circulate the air. [. . . ] Do not dispose of the batteries in a fire as they may explode. Do not install the batteries with the polarity (+/­) reversed. Keep batteries and other things that could be swallowed away from young children. Unit is engineered with adjustable louvers to direct discharge airflow. [. . . ]