User manual FENDER ELITE PRECISION BASS II

[. . . ] Wait until the unit is completely dry before reconnecting it to power. 25 cm)of unobstructed air space behind the unit to allow for proper ventilation and cooling of the unit. This product should be located away from heat sources such as radiators, heat registers, or other products that produce heat. [. . . ] This product may be equipped with a polarized plug (one blade wider than the other). If you are unable to insert the plug into the outlet, contact an electrician to replace your obsolete outlet. Do not defeat the safety purpose of this plug. Protect the power supply cord from being pinched or abraded. This product should only be used with a cart or stand that is recommended by the manufacturer. The power supply cord of this product should be unplugged from the outlet when left unused for a long period of time, or during electrical storms. This product should be serviced by qualified service personnel when: the power supply cord or the plug has been damaged; or objects have fallen, or liquid has been spilled onto the product; or the product has been exposed to rain; or the product does not appear to operate normally or exhibits a marked change in performance; or the product has been dropped, or the enclosure damaged. Do not drip nor splash liquids, nor place liquid filled containers on the unit. cAUTION: No user serviceable parts inside , refer servicing to qualified personnel only. The FOOTSWITCH can also be used to switch ON/OFF the VIBRATO effect. POWER INDICATOR - Illuminates when the amplifier is ON and receiving power (unless the bulb has failed). If the amplifier repeatedly blows connected at this jack when the amplifier is ON. A fuses, take the amplifier to an authorized Fender speaker impedance load of 8 should be used to avoid Service Center. This jack is wired in parallel with and frequency ratings shown on the Rear Panel of your the INTERNAL SPEAKER JACK {E} and affects the amplifier. STANDBY - Push DOWN to put the amplifier into VIBRATO and REVERB effects. Push UP to put the amplifier into will not function without the FOOTSWITCH plugged in. This eliminates warm-up time when returning the amplifier to The tube bias and balance adjustments on your `65 Deluxe Reverb are factory adjusted and should provide years of service before needing attention. If the sound quality of the amp has degraded noticeably, the tubes, may be worn and some, usually the output tubes, may need replacement. [. . . ] This eliminates warm-up time when returning the amplifier to The tube bias and balance adjustments on your `65 Deluxe Reverb are factory adjusted and should provide years of service before needing attention. If the sound quality of the amp has degraded noticeably, the tubes, may be worn and some, usually the output tubes, may need replacement. If you are unsure about the condition of your tubes, take your amplifier to an authorized Fender Service Center. [. . . ]