User manual FENDER PA 135

[. . . ] - Solid green indicates battery is fully charged. Allows you to send the audio signal from the P10W to an external amplifier, mixer or recording device. (9) 1/8" (3. 5mm) Auxiliary Input (for connecting CD, Cassette, or audio line output from another device like a computer sound card). (10) DC Power Input Jack (plug in the battery charger here). [. . . ] In most cases, this should be no more than a few feet. Wireless Flexibility - The Passport Way The P10W is available in two wireless frequencies - 169. 505MHz and 171. 905MHz. The wireless frequency of your P10W is printed on the bottom of the microphone and the bottom of the main unit. These same frequencies are available as wireless systems for other Passport products. The output of the wireless microphone (the transmitter) is sent all around you. This means that if you had several P10W's (all the same frequency) they would all receive the signal from your microphone. Think of it as a paging system - put P10's in every room of your house or office and when you speak into the microphone, your voice comes out of all the speakers - each with their own volume controls!A powerful feature is that one microphone can send signals to different Passport systems. For example, an airline ticketing agent is using a P10W as a communication tool at thier gate. Larger Passport systems (P150 or P250) equipped with wireless receivers are set up throughout the terminal. As the agent announces events taking place at that gate, everyone in the terminal can also hear the information. - Green, blinking indicates charging in progress. - Solid green indicates battery is fully charged. If the indicator does not immediately start to blink green, it may be due to excessive power drain of the battery. The indicator should begin to blink after 10 to 15 minutes. If the battery charge indicator fails to light, it may be due to a faulty battery. Replacing, or using a second Battery With proper care and charging, it is unlikely that it will be necessary to replace the battery in the P10W. If you plan on using the P10W for extended periods of time, you may want to purchase a second battery. The battery is a standard 12 volt 2. 7 amp gel cell and is available from Fender directly, or from Authorized Fender Audio dealers. To replace the battery: - Open the battery compartment by pressing down on the two tabs at the top of the battery compartment. - The battery is "spring loaded" behind an interior rear panel. Remove this panel by sliding it upwards. [. . . ] You will find that if you use the microphone this way, you can speak in a normal voice and be heard clearly. Speaking loudly can cause your voice to distort. Experiment with what is most comfortable for you. - The closer the mic is to your mouth, the louder you will be. [. . . ]