User manual FERMAX BLUETOOTH STAND-ALONE ACCESS CONTROL V02.08

[. . . ] It is important to note that coverage testing must be carried out simulating a real situation of approaching the door, not stationary, at a certain distance and in the most realistic possible position. It must be added that the bluetooth access control works even in places where there is no telephone coverage (GSM), since it uses another communication system that does not entail any cost. BLUETOOTH RECEIVER CONFIGURATION Compatible Telephone Types Bluetooth access control works with any mobile telephone that includes Bluetooth connectivity among its features. System Operating Modes Depending on the security needs, the system can operate in different modes: · Working with list of authorised telephones: A list memorised in the receiver that is used to specify which telephones have the right to open the door. [. . . ] the configuration commands will be entered with this name. The telephone designated as administrator does not need to be on the list of authorised telephones. Modify the bluetooth name of the telephone that is to act as administrator by the code, in capital letters, corresponding to the function to be carried out (authorise users, delete. The table on the next page shows the list of codes and the action associated with each of them. Place the telephone that is to be administrator and the telephones to be added to the list, if any, close to the receiver. After approximately 20 seconds, the telephone acting as administrator will be asked for the Administrator PIN, NOT the User PIN. The administrator PIN code comes preset from the factory. Once the administrator PIN has been introduced, the receiver will open the door twice, indicating that the maintenance order has been carried out. If the PIN is not entered correctly, the administration order will not be carried out. From this moment, the system returns to normal operating mode, and any PIN requested will always refer to the normal PIN used to open the door. Change the name of the bluetooth telephone for another different one of the administrator codes. 3 receptors or subsequent versions can also be configured from a PC or PDA with bluetooth connectivity and the corresponding programming software. The programming software can be downloaded from the Fermax webpage: www. System «Default» Configuration The factory configuration of the system is: - Operating mode WITHOUT authorised phones list with PIN request - User PIN: 1234 - Administrator PIN: 4444 - Door open timing: 3 sec. Used to create the list of authorised telephones. sets the receiver in stand-alone learning mode , automatically adding any telephones nearby at that moment to the list. They are added after those already in the list, without exceeding the maximum limit of 40. At every stand-alone learning session, a maximum of 4 new telephones can be added. So, if you need to add another one, you will have to do it in blocks of 4. It is important that there are no more than 4 in the coverage radius, because otherwise we shall not know which ones have been added. This process is carried out at low power level, regardless of the power level programmed. Change Open Door Timing: Used to specify the open door duration in seconds (2 digits «XX»); example: 05 seconds, 12 seconds. [. . . ] The PDA can only be used to programme the receptor (if the programming software is installed, which is available from the fermax webpage). What happens if there are several telephones near the receiver?A) In PIN code request mode (with or without list of authorised telephones) or with Confirmation: The receiver detects the nearby telephones and alternates the PIN request among the telephones detected, with a 20 second interval, in order to avoid asking the same telephone twice in a row. B) Automatic Mode (with list of authorised telephones without PIN): The receiver detects the telephones nearby, and if there is more than one authorised telephone will open the door with an interval of 6 seconds. [. . . ]