User manual FESTOOL CS 50 EB FLOOR

[. . . ] EC-Declaration of Conformity: We declare at our sole responsibility that this product is in conformity with the following standards or standardised documents: EN 61029-1, EN 61029-2-1, EN 55014-1, EN 55014-2, EN 61000-3-2, EN 610003-3 in accordance with the regulations 2006/42/EC, 2004/108/EC. Bench-mounted circular saw and circular trimming saw CS 50 EB/CS 50 EB Floor Technical data Cutting depth at 90°/45° Inclination max. Drawing length Saw blade (diameter x cutting width) Idling speed Power consumption Bench dimensions (length x width) Bench height with / without foldaway legs Weight without foldaway legs Weight of foldaway legs The specified illustrations can be found at the beginning of the operating instructions. 1 Symbols Warning of general danger Read the operating instructions/notes CS 50 EB/CS 50 EB Floor 0 - 50 mm/0 - 40 mm -2° to 47° 300 mm 190 x 2 , 6 mm 1600 - 4200 rpm 1200 W 600 x 400 mm 900 mm/375 mm 19 kg 2 kg b. [. . . ] 5 m/s² The emission values specified (vibration, noise) were measured in accordance with the test conditions stipulated in EN 61029 and are intended for machine comparisons. They are also used for making preliminary estimates regarding vibration and noise loads during operation. The emission values specified refer to the main applications for which the power tool is used. If the electric power tool is used for other applications, with other tools or is not maintained sufficiently prior to operation, however, the vibration and noise load may be higher when the tool is used. Take into account any machine idling times and downtimes to estimate these values more accurately for a specified time period. This may significantly reduce the load during the machine operating period. 4 Residual risks In spite of compliance with all relevant design regulations, dangers may still present themselves when the machine is operated, e. : - Workpiece parts being thrown off, - Parts of damaged tools being thrown off, - Noise emission, - Sawdust emission. 4 Setting up, commissioning Ensure that the floor around the machine is level, in good condition and free of loose objects (e. 1 Mounting the machine The machine can be set up with or without the legs folded out (Fig. 1 and 2) (the , , Floor" model does not include folding legs). To fold out the legs, open the four rotary knobs (1. After folding out the legs, retighten the four rotary knobs. So that the machine stands securely, the length of one of the legs can be changed by turning the cap on the end (1. 3 Applications The machine can be used as a bench-mounted circular saw or as a circular trimming saw. 8) downwards, and use the hand grip to pull the saw unit forwards until it locks into place. The saw unit is now in a central bench position and the machine can be used as a bench-mounted circular saw. 9) is swung downwards, it can be used to move the saw unit backwards and forwards for drawing cuts. the backward movement is supported by spring force. Dust extraction The PRECISIO has two extraction connections: the upper protective cover (2. 3) with a diameter of 27 mm, and the lower protective cover (2. The extraction set CS 70 AB (488292, included in scope of delivery for CS 50 EB) joins both of the extraction connections so that a Festool extractor module can be connected. [. . . ] The cutting width can be set using the scales (1. 4) to guide the workpiece safety past the saw blade. When not in use, place the work-piece holder in the storage compartment (2. Using accessories and consumable material from other suppliers will most likely affect the quality of your working results and limit any warranty claims. [. . . ]