User manual FESTOOL CS 70 ST

[. . . ] 1) Guide unit consisting of: 2 guide rods mounted on 2 supports with 2 legs 1 Open-end spanner size 17 1 Open-end spanner size 10 1 Allen key 5 mm 1 Adjusting bracket, front 4 Bolts M6x16 4 Washers Ø 6 4 Bolts M8 x 25 2 Fitting angle 4 Square nuts 1 Washer 4 mm thick (this washer is only needed as a compensating washer when extension tables and sliding table are fitted) 1 Adjusting bracket, rear Complete table, consisting of: aluminium profile plate with fitted roller supports with guide rollers and scraper Extra clamp for stop guide And support must lie against one another following assembly, do not tighten bolts yet. Suspend entire guide unit (rods) by suspension lugs in the notches in the fitting angles (2. [. . . ] 9) each onto the front and rear of the table frame of the PRECISIO (Fig. 10) into the corresponding square hole beneath the saw table for the fastening bolt lying towards the middle of the table. 4) on the table frame and screw in place with bolt (2. The nut for the second fastening bolt is stuck to a strip as an assembly aid. First insert a nut from the front into the lateral opening (2. Then remove strip and insert second nut into the rear opening and screw rear fitting angle in place. 2 Adjusting the table height A separate adjustment must be carried out at the front and rear support. Set correct height and adjusting screw (3. If the sliding table is correctly adjusted the gap between the underside of the stop and the base table is the same across the whole width. 2 Adjusting the parallelism A separate adjustment is necessary at the front and rear supports. Adjust parallelism of both tables with adjusting screw (3. Set stop guide so that the front edge of the stop is exactly flush with the outer table edge of the PRECISIO. [. . . ] 1) and remove from frame with bolt head (5. 2 Réglage de la hauteur de table Il convient d'effectuer le réglage nécessaire séparément sur le support avant et sur le support arrière. [. . . ]