User manual FESTOOL LRS 400

[. . . ] Untidiness in working areas increases the risk of an accident. Please take your surroundings into consideration. Do not leave pneumatic tools out in the rain. Do not allow others to touch the pneumatic tool or the compressedair hose. [. . . ] have your pneumatic tool repaired by a qualified specialist. This pneumatic tool corresponds to the relevant safety regulations. Repairs should only be carried out by a qualified specialist. The operator is otherwise at risk of an accident. Only trained and qualified persons are permitted to set up, adjust and operate this air tool. Persons without the relevant qualifications and training are more likely to cause accidents. Modifications may reduce the effectiveness of safety devices and pose a greater risk to operating personnel. Prepare to counteract normal or sudden movements - hold the machine with both hands. 2 Machine-related safety instructions - The manufacturer's handling and processing instructions must be observed without fail if explosive or self-igniting dusts are likely to occur during sanding. - If dust dangerous to health is produced during sanding, the machine should be connected to an appropriate extraction device and the safety regulations that apply to the working material should be observed. - The operating pressure should not exceed 6. - The machine should only be operated with sandpaper. Using the Festool service unit VE guarantees this. - Only use original Festool accessories. - Wear suitable protection such as ear protection, safety goggles, a dust mask for work which generates dust, and protective gloves when working with raw materials and when changing tools. - The permissible rotational speed of the accessory must be at least as high as the maximum speed specified on the machine. Accessories that rotate faster than the permissible level can rupture. - Proceed with caution in unfamiliar surroundings that may contain electricity or other supply cables that harbour hidden dangers. Make sure that there are no electrical cables, gas pipelines or similar that, if damaged, could pose a hazard when the machine is used. 3 Residual risks In spite of compliance with all relevant design regulations, dangers may still present themselves when the machine is operated, e. Workpiece parts being thrown off, · Parts of damaged tools being thrown off, · 3 Noise and vibration information The typical values determined in accordance with EN ISO 15744are: Sound pressure level 80 dB(A) Noise level 91 dB(A) Measuring uncertainty allowance K = 3 dB The noise level can exceed 85 dB(A) during operation. Vibration emission level ah an uncertainty K measured in accordance with EN ISO 8662: Handle ah = 4, 5 m/s² K = 2, 0 m/s² Auxiliary handle ah = 4, 0 m/s² K = 2, 0 m/s² The emission values specified (vibration, noise) were measured in accordance with the test conditions stipulated in EN ISO 15 744/EN ISO 8662 and are intended for machine comparisons. [. . . ] 8 Disposal Do not throw the tool in your household waste!9 Warranty For our tools, we give warranty for material and production defects in accordance with the locally applicable legal provisions, but in any case for at least 12 months. Within the EU member states, the warranty period is 24 months (verification through invoice or delivery note). Damage caused by, in particular, natural wear, overloading, incorrect handling, or damage caused by the operator, or damage caused through use of the equipment contrary that specified in the operating manual, or damage which was known at the time of purchase, is not covered by the warranty. [. . . ]