User manual FESTOOL PSBC 400 EBC

[. . . ] Hour minutes seconds kilograms diameter tip, hint Degree centigrade Newton metre millimetre amps hour watt hour delay fuse with 4 amps Warning of general danger Risk of electric shock Safety instructions General safety instructions wARNING!Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. [. . . ] L The cordless jigsaws can be used with all Festool battery packs of the BPS series. Always remove the belt clip from battery packs from the BPC series prior to use. LED yellow - lit continuously Charger is ready to use. LED green - flashing quickly Battery pack is charged to maximum capacity. LED green - flashing slowly Battery pack is charged with reduced current, LiIon is charged to 80 %. LED green - lit continuously Battery pack is fully charged, or charging is not started again, because the battery is charged to more than 80 %. Incomplete contact, short circuit, battery pack faulty, etc. There are two elongated holes on the back of the TRC 3 for mounting the charger to a wall using two screws (e. Round head or flat head screw with shank diameter of 5 mm). X Insert the two screws into the wall at a distance of 96 mm from one another and leave the screw heads protruding approx. Consider the pictures on the fold-out page. Risk of injury, electric shock X Always disconnect the battery pack before any type of work on the machine! Using the chip guard The chip guard [1-1] prevents chips flying away and improves the efficiency of the chip extraction system. X Using minimal pressure, push the chip guard [1-1] downwards. The number of strokes can be adjusted steplessly with the adjusting wheel [1-5] between 1500 and 3800 rpm (PSBC 400 EB: 1000 - 3800 rpm). This enables you to optimise the cutting speed to suit the respective material. In position A, the automatic load detection is activated: The stroke speed is reduced in idling and is controlled to the highest value when the blade enters the workpiece. Recommended stroke speed (position of the adjusting wheel) Hard and soft wood, plywood board, plywood, chip board Hardboard Plastic Ceramic, aluminium, non-ferrous metals Steel A 4-A 3-A 3-5 2-4 Instead of the saw table, the angle table WT-PS 400 or adaptation table ADT-PS 400 can be installed at the support. Never saw without the saw table, or one of the other tables offered in the Festool accessories program. The splinterguard makes cuts with splinter-free cutting edges possible, even on the exit side of the saw blade. X With the machine switched off, push the splinterguard [4-1] onto the guide up to the saw blade [4-2], X switch on the jigsaw, X with the machine running (stoke speed position 5), push the splinterguard in on a flat plane until it is flush with the front edge of the saw table. In order to process different materials with an optimum feed movement the pendulum jigsaws have an adjustable pendulum stroke. [. . . ] Observe the following instructions: ­ Keep the air slits on the machine and the charger free and clean to ensure adequate cooling. The equivalent amount of lithium in the LiIon battery pack is less than the applicable limit value and certified as per UN manual ST/SG/ AC. The LiIon battery pack is therefore not subject to national and international dangerous goods regulations, neither as an individual component nor as a fitted machine component. However, dangerous goods regulations may apply When several battery packs are transported, in which case you may have to fulfil special conditions. [. . . ]