User manual FESTOOL RS 100 Q-PLUS

[. . . ] Connect the electric power tool to a suitable extraction system. To protect your health, wear a P2 protective mask. 3 Noise and vibration information The typical values determined in accordance with EN 60745 are: Sound-pressure level 80 dB(A) Sound-power level 91 dB(A) Measuring uncertainty allowance K = 3 dB Wear ear protection!1 Intended use As specified, the machines are designed for sanding wood, plastic, metal, stone, composite materials, paint/varnish, filler and similar materials. [. . . ] Always switch the machine off before connecting or disconnecting the mains lead!4 for connection and disconnection of the power cable. 3 Abrasives to clamp Festool offers perforated abrasives to clamp. Unperforated abrasives can be perforated with the „Lochfix“ (accessory). - Before affixing any abrasives, attach a Stickfix abrasive sheet to the sanding pad first so that the adhesive coating on the Stickfix sanding pad is not damaged. Press the levers to release the clamping devices. Once clamped in position, make sure the abrasive paper is taut and sits flat on the sanding pad. 5) can be attached for tasks where the front edge of the sanding pad sands up to edges. 4 Machine settings Always remove the power supply plug from the socket before carrying out any work on the machine. Dust extractors prevent large accumulations of dust in the air in the working environment and dirt collecting at the workplace. You can connect a Festool extractor with an extractor hose diameter of 27 mm to the extractor connector (1. Sanding dust is extracted through the extraction channels in the sanding pad directly to the material removal point. 2) to allow air to enter prevents the machine from sticking to flat surfaces when processing workpieces. The further you open the bypass, the more air is drawn in. 5 Instructions on application Never overload the tool by using too much pressure!The best sanding results are achieved when applying moderate pressure. The sanding performance and quality depend mainly on the choice of the right sanding material. Metalworking The following precautions are to be taken when processing metals for safety reasons: - Pre-connect a residual current circuit-breaker (FI, PRCD). Stickfix abrasives The appropriate Stickfix sanding paper and Stickfix sanding felt can be fastened quickly and easily onto the Stickfix sanding pad. The self-adhesive sanding material is simply pressed onto the sanding base and held safely in place by the Stickfix sanding base velcro surface. After use, the StickFix sandpaper is simply pulled off. 6 Accessories Use only original Festool accessories and Festool consumable material designed for this machine because these system components are designed specifically for the machine. [. . . ] 8 Disposal Do not throw the power tool in your household waste! dispose of machines , accessories and packaging at an environmentally-responsible recycling centre. EU only: European Directive 2002/96/EC stipulate that used electric power tools must be collected separately and disposed of at an environmentally responsible recycling centre. 9 Warranty For our tools, we give warranty for material and production defects in accordance with the locally applicable legal provisions, but in any case for at REACH for Festool products, their accessories and consumables REACh is a European Chemical Directive that came into effect in 2007. [. . . ]