User manual FESTOOL SHINEX RAP 150 FE

[. . . ] ­ Do not use accessories which are not specially designed and recommended by Festool. Just because the accessory can be attached to your power tool, it does not assure safe operation. ­ The rates speed of the accessory must be at least equal to the maximum speed marked in the power tool. Accessories running faster than their rated speed can break and fly apart. [. . . ] kickback will propel the tool in direction opposite to the wheel's movement at the point of snagging. Use special care when working corners, sharp edges etc. Do not attach a saw chain woodcarving blade or toothed saw blade. Safety Warnings Specific for Polishing Operations ­ Do not allow any loose portion of the polishing bonnet or its attachment strings to spin freely. Tuck away or trim any loose attachment strings. Loose and spinning attachment strings can entangle your fingers or snag on the workpiece. ⭠Prevent liquid polish from entering the machine. The penetration of liquid polish into the electric power tool increases the risk of an electric shock. 3 Emission levels Levels determined in accordance with EN 60745 are typically: Sound pressure level Noise level Uncertainty LPA = 81 dB(A) LWA = 92 dB(A) K = 3 dB The emission values specified (vibration, noise) were measured in accordance with the test conditions stipulated in EN 60745 and are intended for machine comparisons. They are also used for making preliminary estimates regarding vibration and noise loads during operation. The emission values specified refer to the main applications for which the power tool is used. If the electric power tool is used for other applications, with other tools or is not maintained sufficiently prior to operation, however, the vibration and noise load may be higher when the tool is used. Take into account any machine idling times and downtimes to estimate these values more accurately for a specified time period. This may significantly reduce the load during the machine operating period. Risk of accident X The mains voltage and the frequency of the power source must correspond with the specifications on the machine's name plate. X In North America, only Festool machines with the voltage specifications 120 V/60 Hz may be used. Press the switch again to release the knob. Operating noise Damage to hearing X Use ear protection!Vibration emission value ah (vector sum for three directions) and uncertainty K measured in accordance with EN 60745: Risk of injury, electric shock X Always pull the plug out of the socket before performing any type of work on the machine!1 Electronics The machine features full-wave electronics with the following features: Smooth start-up The electronically controlled smooth start-up ensures that the machine starts up jolt-free. Speed control The speed reached when the switch [1-4] is pressed all the way in can be set to between 600 and 2100 rpm using the adjusting wheel [1-2]. This enables you to optimise the cutting speed to suit the surface (see table). [. . . ] Complaints can only be accepted if the tool is returned while still assembled to the supplier or an authorised Festool Customer Service workshop. Keep the operating manual, safety instructions, spare parts list and purchase receipt in a safe place. Otherwise the current warranty conditions of the manufacturer shall apply. Note Due to continuous research and development work, we reserve the right to make changes to the technical content of this documentation. [. . . ]