User manual FIELD CONTROLS 01575700

[. . . ] NOTE: This unit may require a supplemental 24V/40VA Transformer. This device MUST be installed by a qualified agency* in accordance with the manufacturer's installation instructions. The definition of a qualified agency is: any individual, firm, corporation or company which either in person or through a representative is engaged in, and is responsible for, the installation and operation of HVAC appliances, who is experienced in such work, familiar with all the precautions required, and has complied with all the requirements of the authority having jurisdiction. SAFETY CONSIDERATIONS WARNING: Never expose eyes or skin to UVC light from any source. · Looking directly at the UVC light may cause permanent eye damage or blindness. · Never operate the UV-Aire Air Purifying System out of the plenum. [. . . ] Cut out the large opening (1-1/2" hole) on the template. (Refer to template as shown in Figure 3) 5. Using a ¼" to ½" drill bit, drill a viewport hole as indicated on the template. Optional Light Shield: The light shield may be mounted at virtually any angle. However, when deciding on a suitable location, the mounting screw head can not be in the shaded area of template. (See Figure 4 to view areas to avoid. ) 7. Press shield onto duct wall then secure with screws. (See Figure 5) Figure 1 Figure 2 Figure 3 Figure 4 Head of mounting screw CAN NOT be located in shaded area Figure 5 WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness. Never operate the UV-Aire Air Purifying System out of the plenum. Avoid touching the glass portion of the lamp with your hands. NOTE: Wear disposable, nonabsorbent protective gloves prior to inspection procedure in case of accidental breakage of glass. We recommend inspecting and cleaning the lamp at least every 6 months. Such as: the type of air filter, duration of use and replacement cycle. To maintain maximum output intensity, replace the UV-Aire lamp annually. The lamp should operate continuously for maximum lamp life and light effectiveness. Diagram A Diagram B WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness. Never operate the UV-Aire Air Purifying System out of the plenum. Avoid touching the glass portion of the lamp with your hands. Page 5 REPLACEMENT PROCEDURE WARNING: Disconnect power to the transfomer before starting replacement procedure. NOTE: Wear disposable, non-absorbent protective gloves prior to replacement procedure in case of accidental breakage of glass. Rotate the UV-Aire ballast assembly counter-clockwise until it stops. (See Figure 9) Remove the ballast assembly and lamp from the mounting base. [. . . ] If skin surface is pierced, seek medical attention immediately. Do not wire the unit into the appliance 24 volt fan or thermostat circuit. This will cause premature ballast or lamp failure and void the warranty. For proper operation, the unit requires 24VAC at all times. [. . . ]