Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual FIELD CONTROLS 01986800. We hope that this FIELD CONTROLS 01986800 user guide will be useful to you.
Lastmanuals help download the user guide FIELD CONTROLS 01986800.
Manual abstract: user guide FIELD CONTROLS 01986800
Detailed instructions for use are in the User's Guide.
[. . . ] Set the draft adjustment plate on the draft inducer to maximum setting before installing NOTE: The draft inducer proving switch (DIP-1) and DI-CK Control Kit adapter kit are not required with the DI PAK MV and MVFG kits.
II. INSTALLATION OF GAS PRESSURE SWITCH CAUTION: Check gas control valve pressure. Pressure must not exceed 14" WC pressure. [. . . ] Replace the pressure tap plug with the 1/8" pipe nipple and pipe tee. Install pressure tap plug at the bottom of the pipe tee. Install the gas pressure switch into the side of the pipe tee. The gas pressure switch is supplied with a restrictor orifice in the inlet and outlet ports. With these orifices in place, the switch does not need to be vented. This feature complies with current ANSI standards for gas regulators. (See Figure 4) CAUTION: If for any reason the system has shut down during operation, the cause of the system failure should be investigated and corrected before resetting the safety switches and restarting the system. DRAFT HOOD SAFETY SWITCH INSTALLATION NOTE: 12 ga. wire must be used when wiring safety spillage switches, to reduce the voltage drop in the thermocouple circuit. SYSTEM CONTROL CHECK OUT PROCEDURES GAS PRESSURE SWITCH FOR WATER HEATER 1. Follow water heater manufacturer's instructions to light pilot. Turn the gas control valve to the ON position. Then adjust the thermostat to call for heat, which will energize the venter motor. Turn gas control valve to the PILOT position, which will start a 1 to 3 min. Repeat Step 1 and 2 to ensure proper operation. Allow the water heater to heat up to operating temperature, then disconnect the power to the gas pressure switch. Adjust the thermostat to call for heat with the venter inoperative. Allow approximately 2 minutes of flue gas spillage for the spillage switches to sense the spillage and disrupt the thermocouple circuit, halting the gas flow to the pilot and burner. [. . . ] Allow approximately 2 minutes of flue gas spillage for the spillage switches to sense the spillage and disrupt the thermocouple circuit, halting the gas flow to the pilot and burner. Reset the spillage switches and light the pilot, then perform a second safety spillage test (Steps 1 and 2). CAUTION: If for any reason the system has shut down during operation, the cause of the system failure should be investigated and corrected before resetting the safety switch and restarting the system.
Page 3
VI. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE FIELD CONTROLS 01986800
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual FIELD CONTROLS 01986800 will begin.
