User manual FIELD CONTROLS 46080800

[. . . ] (See Figure 3) If the appliance has a factory built-in switch, mount a single switch 3 inches from the side opposite the factory switch. The switch should not contact the metal. They should be mounted at least 1 inch below the hood opening. (See Figure 4) Mount with supplied sheet metal screw. [. . . ] VERTICAL DRAFT HOOD (See Figures 5 & 6 or Figure 13 for water heaters) 1. Two (2) switches are recommended on appliances without a factory supplied spill switch. Mount the spill switch onto the bottom edge of the draft hood and the second switch (if used) approximately 90 degrees from the first switch or 90 degrees from the factory supplied switch. The switch should not contact the metal. They should be mounted at least 3/4 inch below the hood opening. (See Figure 6) Mount with supplied sheet metal screw. Figure 1 Figure 2 Figure 3 Figure 4 Figure 5 Figure 6 Page 2 DRAFT CONTROLS (See Figures 7 & 8) NOTE: GSK style switches are designed for draft control models 4" MG1 through 9" MG1. Larger size draft controls require the FTS Series switches. Locate the spill switch along the bottom edge of the draft control ring. (See Figure 11) 30 MILLIVOLT WATER HEATER: Two (2) switches are recommended for this application. The application requires a TCA-1 Thermal Couple Junction block (P/N 46082700 NOT INCLUDED) and a 6 foot length of 12 ga. two (2) wire conductor (NOT INCLUDED) to wire between the spill switches and the TCA-1. CAUTION: Shut off gas supply before working on appliance. Remove thermocouple from gas control valve. Thread the junction block into the thermocouple port and thread the thermocouple into the bottom of the junction block. Mount the two (2) spill switches onto the draft hood so the switches do not contact any metal. Connect the one terminal of each switch with 12 ga wire and then connect it to the thermocouple junction block. Next, connect the two remaining terminals together using a short length of 12 ga wire. [. . . ] Connect the one terminal of each switch with 12 ga wire and then connect it to the thermocouple junction block. Next, connect the two remaining terminals together using a short length of 12 ga wire. Route and secure the wires to the water heater enclosure with acceptable hold down tabs, keeping the wires away from any hot surface area. SYSTEM CHECK-OUT PROCEDURE FOR GAS SPILLAGE SWITCH CONTROL 1. [. . . ]