User manual FIELD CONTROLS 46427300

[. . . ] Feet 12" 18" 28" 9 14 22 120/240 120/240 120/240 0. 5 0. 5 1. 1 60 60 60 30 30 60 150° 150° 150° 37 µW/cm2 73 µW/cm 2 1500 2000 3000 105 µW/cm2 WARNING: Before installing or servicing a humidifier, air filter, heat system, or this unit, etc. , always turn all power OFF and have units unplugged. Electrical shock can cause personal injury or death. Never expose eyes or skin to direct UVC light from any source. Determine a suitable location on either the supply or return for the unit as shown in Figure 1. [. . . ] (See Figure 11) The angle bracket may be mounted in 4 positions allowing the bulb to either be angled up and down or left to right, depending upon duct design. (Figures A-D) NOTE: Be sure to note location of lamp hole in bracket relative to unit base. Figure 10 Figure 11 Figure A Figure B Figure C Figure D LAMP INSTALLATION This unit is listed for use with Field Controls' lamps ONLY. You will need to determine proper lamp selection based on duct size and desired configuration. (Refer to configuration table on page 6 of this manual) 16. Wipe off lamp being sure not to touch lamp with bare hands. The oils in your hands may cause the lamp to prematurely expire. Insert lamp through hole in bracket until lamp is snug against the bracket. (See Figure 12) Figure 12 WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness. Never operate the UV-AireTM Air Purifying System out of the plenum. Avoid touching the glass portion of the lamp with your hands. Page 4 18. Swing securing bracket over end of lamp and hand-tighten the provided wing nut on stud. Plug ballast plug into end of lamp and reconnect power supply. Flip the red power switch to the on position. (Light on switch should be on indicating power. ) 21. Look through view port to be sure lamp is working. (The view port is covered with a plastic lens that blocks the UVC rays. ) 22. If the lamp is not glowing, make sure the wiring is correct and that the ballast is plugged in securely to lamp. If lamp still does not glow, contact technical support at 1-252-522-3031 for further assistance. After unit has been found to be working properly, note date of installation on inside cover, close cover and engage latch. Apply supplied wire tie to latch or other locking mechanism to provide safety. WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness. [. . . ] At the time of request for warranty service, the purchaser must present proof of purchase documentation which includes the date of purchase (for example, a receipt or sales slip). If the malfunction or failure is a result of defects covered by this warranty, Field will, at its option, repair the product or replace it and return it to the purchaser. This warranty is limited to the original retail purchaser and is not transferable. The warranty does not cover damage due to accidents, abuse, tampering or misuse, nor does it cover damage resulting from service persons other than Field. [. . . ]