User manual FIELD CONTROLS 46453300

[. . . ] WARNING: DO NOT mount this unit outdoors. · This product is designed for indoor installation only (i. e. attics, crawl spaces, basements, etc. ). I. INDICATION FOR USE This product is not sold as a medical device and is not for the purpose of diagnosis of any disease or condition nor for use in the mitigation, treatment, or prevention of any disease or condition. GENERAL INFORMATION There are different size units available, depending on the square footage of your home. [. . . ] Avoid touching the glass portion of the lamp with your hands. Page 3 Apply supplied "Duct Seal Kit" according to instructions included in kit. 4. Loosen the two side screws on the unit and slide cover off of unit exposing the internal components. Determine whether to use flat or angled bracket. (Refer to UV-Aire Configurations in Section III for aid in this decision) a. Remove the two hex nuts and flat bracket from included bagged hardware. Install the flat bracket and secure to the unit base with the hex nuts provided. Angled Bracket Installation NOTE: For angled bracket mounting, refer to specifications outlined by Diagrams A & B for mounting distances in the "Angled Lamp Mounting Bracket Specifications" in section III. Remove the two hex nuts and angled bracket from included bagged hardware. Install the angled bracket and secure to the unit base with the hex nuts provided. (See Figure 15) NOTE: Be sure to note location of lamp hole in bracket relative to unit base. Figure 15 6. Mount the unit base to the duct using the four mounting screws provided. Wipe off lamp being sure not to touch lamp with bare hands. The oils in your hands may cause the lamp to prematurely expire. Figure 16 (This figure illustrates duct board mounting, but the procedure is the same for metal duct) WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness. Never operate the UV-AireTM Air Purifying System out of the plenum. Avoid touching the glass portion of the lamp with your hands. Page 4 8. Insert lamp through hole until lamp cannot be inserted any further. Swing swivel bracket over end of lamp and hand-tighten the wing nut on stud. (See Figure 18) Figure 17 Figure 18 10. Plug the power cord into a standard electrical outlet. NOTE: Seal the joints and seams of the plenum near the mounting location to reduce any direct viewing of light. Flip switch on box to the `ON' position. [. . . ] Never operate the UV-AireTM Air Purifying System out of the plenum. Avoid touching the glass portion of the lamp with your hands. Page 7 IX. FLEX DUCT INSTALLATION For installations on duct systems with a metallic main duct and flex duct branches, follow the instructions in figure 21 below. Figure 21 WARRANTY INFORMATION FIVE YEAR LIMITED WARRANTY (excluding lamps, which have a 90 day warranty, from day of installation) The products of The Field Controls Co. are warranted to be free from defects in material and workmanship under normal use for five (5) years from date of manufacture. [. . . ]