User manual FITNESSQUEST GAZELLE POWER PLUS ASSEMBLY

[. . . ] Begin exercising at Level 1 (zero resistance) and slowly advance to the next level when the current level becomes too easy. The levels increase as you move the pin towards you to the next position. Zero Resistance Level 1 a. Fasten mounting brackets to the outside edges of the left and right foot tubes using (2) hex bolts, (2) washers and (2) nylon nuts. [. . . ] For ease of assembly, raise foot platform slightly so pin can reach mounting bracket. Repeat Steps d and e on right side. Third, attach the frame plates to each side of the base frames using (4) M10 x 95mm hex bolts and spring washers from the fastener pack. These bolts also secure the base frame to the cross tube. Tighten bolts. clip in zero resistance remove 6 M8 x 25mm bolts from right base b. Lying Out Swing Arms replace 2 M8 x 25mm bolts to attach cross tube Move the left and right swing arms to the center of the frame assembly as shown. Make sure the cables lay on the top of all pieces. M10 x 95mm hex bolts front foot platform tube remove 6 M8 x 25mm bolts from left base replace 2 M8 x 25mm bolts to attach cross tube frame plate left frame right frame cross tube pin clip right base frame mounting bracket M10 x 95mm hex bolts frame plate left base frame left swing arm right swing arm ©2003, ©2004 and ©2005 Fitness Quest ® Inc. Gazelle Power PlusTM is a trademark of Fitness Quest® Inc. left frame front c. Left Frame/Swing Arm Assembly Raise the left frame (marked with the L and arrow facing the front) and secure it onto the left base frame using (4) of the M8 x 25mm hex bolts and spring washers you removed in step a. When tightening these bolts, you can use the wrenches provided in either the fastener pack or the hydraulics fastener pack ­ whichever works best for you. Electronics Assembly Step 1: Remove the two small screws from the bottom of the electronics with the screwdriver provided. Insert the two "AAA" batteries in the top housing. Step 2: Attach the bottom housing with the large bolt provided in the bag with the batteries as shown. Step 3: From the front of the unit, place the top housing onto the bottom housing and replace the two small screws you removed in Step 1 as shown. Step 1 Step 2 view as if you are using the unit Step 3 M8 x 25mm hex bolt and spring washer left base frame Remove the two small screws left swing arm axle tube right swing arm d. Axle Tube Assembly Raise the left swing arm up to the top of the left frame. Slip the axle tube through the swing arm from the right. Make sure the arrow on the axle tube is pointing left and the notch on the end of the axle tube is down. IMPORTANT: Slip a large washer onto the axle between the swing arm and the left frame before inserting the axle tube into the left frame. Slide the axle tube through the left frame. [. . . ] As you did before, gently move the axle tube forward and backwards until the notch "catches" in place while pushing the right frame on. Secure everything onto the axle tube with the M8 x 25mm hex bolt, spring washer and washer that is left from your fastener pack. tab end cap front view Attach the end cap onto the frame using a M6 x 40mm Phillips bolt in the lower hole only. Align the water bottle holder on the end cap so the tab on the back of the holder fits into the bottom hole of the end cap. [. . . ]