User manual FLAM FORNO DIMENSIONS

[. . . ] Use the and keys to set the first digit in the password. Repeat the previous step until all four digits of the password are entered. Note: For information on paper parameters as they relate to input trays and output areas see the on-line User's Guide on the Documentation CD provided with your printer or at http://my. Auto (default) Light Medium Light Medium Medium Heavy Heavy Ultra heavy 1 Ultra heavy 2 Ultra heavy 3 [MP Tray only] Auto (default) Light Medium Light Medium Medium Heavy Heavy Ultra heavy 1 Ultra heavy 2 For more information, see the on-line User's Guide on the Documentation CD provided with your printer or at http://my. [. . . ] Long edge feed--face down, top toward the back of the printer. Short edge feed-- face down, top to the right: For more information, see the on-line User's Guide on the Documentation CD provided with your printer or at http://my. Short edge feed--aim the top into the printer: Flap side down, aimed into the printer: The Face-Up exit tray (see the next page) must be used for special media or for heavy papers. Use the straight-through path when printing labels, heavy card stock, transparencies, or when printing from the MP Tray. To prevent damage to the printer, it is very important to check the printer's media settings before printing on thick paper. Labels must cover the entire carrier sheet. Never use envelopes with metal clasps, snaps, windows, or V-flap seals. Never use office transparencies designed for use by hand with marker pens. If you are experiencing frequent paper jams, check the following items. Holding the front top cover by the grip (4), push it gently inwards, then raise it. If you have the optional finisher, push it back into place on the printer. Any time you replace a toner cartridge (a LED lens cleaner is included with each replacement toner cartridge) · If printing is showing signs of faded images, white stripes or blurred letters 1. Use the LED cleaner provided with the toner cartridges or a soft, lint-free cloth to gently wipe each of the four heads (1). Move the cleaner as shown, using a fresh section for each pass. Remove items such as wrist watches or bracelets so they do not catch in the mechanism. If a hard disk drive is installed in the printer, press and hold the Shutdown/Reset button on the control panel for 3 seconds and wait for the display to tell you it is Open Tray 1 side cover and pull out the paper guide plate (1). Gaining access through the gap left by Tray 1, wipe the 3 paper feed rollers (2) with a soft cloth lightly moistened with water. Return the paper guide plate to its original position and close Tray 1 side cover. [. . . ] Gaining access through the gap left by Tray 1, wipe the 3 paper feed rollers (2) with a soft cloth lightly moistened with water. Return the paper guide plate to its original position and close Tray 1 side cover. Key report you wish to print: · (for more information, see the on-line User's Guide on the Documentation CD provided with your printer or at http://my. The report prints and the printer goes back on line. [. . . ]