User manual FLAM MT 72-56 DIMENSIONS

[. . . ] Press down to lock. 8 Quick Setup 4 Install the Toner Cartridge s Lift out and discard toner well cover. s Unwrap toner cartridge. s Shake cartridge side to side to distribute toner. Quick Setup 9 Install the Toner Cartridge (continued) Tab s Remove tape from the toner cartridge. s Install the toner cartridge: a. Lower the right side into the well. 10 Quick Setup Install the Toner Cartridge (continued) s Push the lock lever forward until it stops. s Close the cover. Quick Setup 11 5 Connect to Your Computer We recommend that you use a Bi-directional parallel printer cable. Purchase a cable marked "IEEE 1284 compliant. " To comply with FCC regulations, the cable must be shielded and UL and CSA approved. s Note: FLAMDATA has tested and approved the following bidirectional cable: Part Number 70000803. [. . . ] Insert the wide connector into the parallel port on your printer, then snap both wire clips into the notches on the cable connector. s s s Insert the other end into the parallel port on your computer and tighten the screws. Install the power cord into the printer receptacle, then into an outlet. Turn power ON. 12 Quick Setup 6 Load Paper · Use smooth, low moisture paper rated for copier and laser printers. Paper Feeding · Feeder: 100 sheets/20 lb. max. / letter and legal size Stacking capacity: 30 sheets/ face-up · Letter, legal 13, legal 14, executive, A4, A5, B5, A6, user defined (min. 3" x 5" ) Letterhead /Preprinted Forms · Ink must withstand 392°F (200°C) for 0. 1 second. s Adjust the paper guides. s s Fan a stack of paper (up to 100 sheets/20 lb. max. ) Place paper into the paper input tray. See the online User's Manual for additional information on paper. Quick Setup 13 7 Install the Printer Software You are now ready to install the printer software. The CD-ROM packed with your printer includes the software you need to use your printer. s Printer drivers - needed to use all printer features s Status Monitor software - for on-screen monitoring of printer status and features s Readme files - timely information and notes s Online User's Guide - for viewing or printing Follow these steps to install the printer software for your operating system. Windows 95/98/NT 4. 0 1. Insert the FLAMPAGE 6w CD into your CD-ROM drive. 3" x 5" ) · Letterhead Stationery/ Preprinted Forms: Ink must withstand 392°F (200°C) for 0. 1 second. · Labels and Transparencies: ­ Transparencies, label carrier sheet and adhesive must withstand the fusing process heat of 392° F (200°C) for 1 second. Labels must cover the entire carrier sheet. ­ Use transparencies and label sheets designed for laser printers. s Adjust the guides. s s Insert media face-up, top of page in first. Set Manual Feed and media size in your software. Select print. Quick Setup 18 Printing Envelopes Use this type s Adjust the guides. s s Insert the envelope flap down and to the left. Select manual feed-envelope in your software. Select print. ­ Use envelopes with a smooth, even surface that are designed for laser printers: no metal clasps, snaps, windows, or selfadhesive flaps ­ Maximum weight 24 lbs. ­ Monarch, Com-9, Com-10, DL, C5 19 Quick Setup Purchasing Supplies s s s s s Consult the dealer where you purchased your printer. [. . . ] Consult an Okidata Authorized Sales and Service Dealer. Call 1-800-FLAMDATA (North America only) for the nearest Authorized Sales and Service location. Order toll-free by phone at 1-800-FLAMDATA (1-800-654-3282, North America only), using a major credit card. [. . . ]