User manual FLORABEST KH 4122 OUTDOOR THERMOMETER WITH SOLAR LAMP

[. . . ] Page 7 Switching the illumination on and off . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 7 Exchanging batteries . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 8 Cleaning and Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 8 Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] in the winter, it should be switched off, cleaned and stored in a dry and warm area. emove the batteries to avoid damage to the R batteries themselves or to the solar housing. W Arrange for repair or component exchange work to be carried out only by the Service Centre or qualified electricians. The batteries may not be shortW circuited. Overheating, fire risks or the exploding of the batteries could be the consequence. Never throw W batteries into water or a fire. Chemical fluids may leak from batteries that are very old or exhausted, and these fluids could damage the appliance. You should therefore remove the batteries if you do not require the Outdoor Thermometer for an extended period. Wear protective gloves: Leaking or damaged batteries can cause acid burns if they come into contact with bare skin, thus in these cases you should always wear suitable protective gloves. Use only batterries of the correct size and of the correct type. Tip: Ensure that when the Outdoor Thermometer is removed the support tube and the earth spike are also removed, to avoid any possible danger that they may cause (e. g. stumbling ). Commissioning Assembly / Location selection To obtain the optimal results, place the Outdoor Thermometer in a location at which the solar cell is subject to the maximum amount of direct sunlight. o not place the Outdoor Thermometer under D bushes, trees, overhangs etc which could reduce the total amount of sunlight received. nsure that the solar cell Q and the photo E sensor W cannot be covered or come into shade. nsure that the solar cell Q is not influenced E by other light sources, e. g. If it is, the lamp will not switch on at twilight. During the assembly and the placing of the appliance do not use force, e. g. Screw the temperature tube O onto the support tube E. Insert the earth spike R into the support tube E. Put the earth spike R, on which the thermometer tube O and the support tube E are now placed, into the ground (lawn, flower-bed, etc). Rotate the solar housing P carefully in a clockwise direction onto the thermometer tube O. Remove the protective foil from the solar cell Q should one be placed over it. Switching the illumination on and off The solar housing P requires ca. [. . . ] Notice: The solar housing P requires ca. 2-3 sunny days to completely charge the batteries Y. Leave the solar lamp switched off for this period (Switch position "OFF"). Disposal The packaging comprises exclusively environmentally-friendly material which can be disposed of in your local recycling containers. Do not dispose of electrical appliances with your domestic waste! [. . . ]