User manual FLYMO CONTOUR POWERPLUS CORDLESS

[. . . ] This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the product by a person responsible for their safety. Children should be supervised to ensure that they do not play with the product. Local regulations may restrict the age of the operator. Only use the trimmer in the manner and for the functions described in these instructions. [. . . ] Contact your local approved service centre/dealer/distributor for a replacement battery and for safe disposal of your old battery. Battery Replacement Should your battery need to be replaced contact your local approved service centre or dealer who will remove your old battery and fit a genuine Flymo replacement battery. The other lead should always be connected to the black terminal (-)on the battery. Refit the battery cover and secure with the bolt and nut. Bench Top Re-charging The wall bracket can also be used as a "bench top" stand for re-charging your cordless trimmer. If you are unable to leave your cordless trimmer on permanent charge, re-charge the battery every 3 to 4 months for a full 24 hour charging period to top up the battery charge during winter storage. Switch charger off at the wall socket before connecting or disconnecting the trimmer to the wall bracket. It is recommended that the wall bracket (F2) should be mounted on a smooth, vertical and internal wall which is strong enough to hold the weight of the product, in a well ventilated area between 5°C and 25°C. Position the wall bracket with the two holes at the top. Ensure that when the trimmer is attached the bottom of the trimmer is within 4 inches (100 mm) of the ground, this will make it easier to hang the trimmer and will also ensure that the wall bracket is within easy reach of an electric socket to allow the charger to be plugged in. Fix wall bracket securely to the wall with the plugs and screws provided. Your cordless trimmer can now be attached to the wall bracket for charging. Keep the charger and the trimmer dry at all times. Keep the charger well ventilated during charging. Ensure the product is correctly located into the wall bracket (F2) and the charge connector (G1). Plug the charger (F1) into a suitable household electrical wall socket and switch on. The red indicator lamp on the product (F3) is a power indicator and will continue to glow red even when the battery is fully charged. Full charge will be achieved in 24 hours after which the indicator lamp on the charger (F4) will turn to green. during charging the charger becomes warm. This is normal and means the charger is operating correctly. Re-charge the battery as soon as the cutting power of your product begins to die and slow down. Avoid running the product into "deep" discharge, i. [. . . ] The maximum hand / arm vibration weighted value measured according to EN ISO 5349 on a sample of the above product(s) corresponds to the Value given in the table. Bryt strömmen till laddaren innan trimmen ansluts till eller kopplas från väggupphängningen. Genom att se till att denna produkt omhändertas ordentligt kan du hjälpa till att motverka potentiella negativa konsekvenser på miljö och människor, vilka annars kan orsakas genom oriktig avfallshantering av denna produkt. Batteriet skall lämnas in till en godkänd servicedepå eller till Din lokala återvinningsstation. [. . . ]