User manual FLYMO EASICUT 500CT

[. . . ] Only use the product in the manner and for the functions described in these instructions. Never operate the product when you are tired, ill or under the influence of alcohol, drugs or medicine. The operator or user is responsible for accidents or hazards occurring to other people or their property. Always charge the product indoors and store in a cool dry place - out of the reach of children. [. . . ] Know how to stop the product quickly in an emergency. Never operate the product with damaged guards or without guards in place. Remove Battery Pack before passing product to another person. Avoid operating while people especially children are nearby. Whilst using the product always be sure of a safe and secure operating position. Keep hands and feet away from the cutting means at all times and especially when switching on the motor. Remove the Battery Pack :before leaving the product unattended for any period; before clearing a blockage; before checking, cleaning or working on the appliance; if you hit an object. Do not use your product until you are sure that the entire product is in a safe operating condition; if the product starts to vibrate abnormally. Keep all nuts, bolts and screws secure to be sure the product is in safe working condition. Be careful during adjustment of the product to prevent entrapment of the fingers between moving blades and fixed parts of the machine. After use the product should be stored using the blade cover provided. If over a period of time the battery quickly runs down after a full 5-6 hour charging period, a replacement battery is needed. There will be some charge present in the battery but to ensure maximum running time, recharge your product for 5-6 hours before use. Contact your local approved service centre/dealer/distributor for a replacement battery and for safe disposal of your old battery. Plug the charger (B1) into a suitable household electrical wall socket and switch on. This is normal and means the charger is operating correctly. Re-charge the battery as soon as the cutting power of your product begins to die and slow down. Avoid running the product into "deep" discharge, i. Charging the battery according to these instructions should ensure maximum battery life. Awareness of the environment must be considered when disposing of `end-of-life' product. If necessary, contact your local authority for disposal information. bATTERY DISPOSAL · The battery should be taken to an Authorised Service Centre or your local Recycling Station. [. . . ] Failures due to the following are not covered, therefore it is important that you read the instructions contained in this Operator's Manual and understand how to operate and maintain your machine: Failures not covered by guarantee * Replacing Cutting Line. * Failures as a result of not using the product in accordance with the instructions and recommendations contained in this Operator's Manual. * Machines used for hire are not covered by this guarantee. * The following items listed are considered as wearing parts and their life is dependent on regular maintenance and are, therefore not normally subject to a valid warranty claim: Blades. [. . . ]