User manual FLYMO MT25

[. . . ] Fill the fuel tank through a funnel fitted with a fine filter. Never fill fuel tank completely, only fill to the base of the filler neck. When filling the fuel tank from empty, or when the engine has previously run dry, a minimum of 400cc of fuel must be added (to the level of the line indicated in the diagram) to ensure correct priming of the fuel pump to start the engine. Fill with oil as instructed in your Engine Owners Manual provided with your product. [. . . ] When the engine has stopped, lower the lawnmower to the ground. Before any servicing to the underside of your machine, close the fuel tap, let the engine run until it stops, disconnect the spark plug lead and TIP THE MACHINE ON ITS SIDE WITH THE AIR CLEANER UPPERMOST. Always keep your feet on flat ground with the mower below you on the slope and with the spark plug uppermost to avoid lubricating oil running into the cylinder. Do not use this mower on slopes which are wet or more than 450 from horizontal. Before using the lawnmower, always visually inspect to see that blades and bolts are not worn or damaged. Your lawn will suffer if more than one third of its length is cut at one time. Keep hands and feet away from the blade, a rotating blade cannot be seen. Never use more than 2 cutting height spacers. Spacers can only be fitted between the blade and the fan and never between blade and the bolt (P). Ensure the Operator Presence Control is released, when the engine has stopped rotating - disconnect the spark plug lead. Always handle the blade with care - sharp edges could cause injury. If you do not intend to use your lawnmower for long periods it is advisable to follow this procedure after use: 1. As fuel runs out the engine will begin to stop, tilt the lawnmower slightly. Once the engine has stopped, release the Operator Presence Control. Keep your lawnmower clean - grass clippings left in any of the air intakes, around the engine or under the deck could become a potential fire hazard. Do not clean with chemicals, including petrol, or solvents - some can destroy critical plastic parts. Remove grass from under the deck with a piece of wood or similar. Using a soft brush - remove grass clippings from around the engine and from all air intakes. Remove the fan, See 'Removing and Fitting the Blade and Fan', and clean with a soft brush. Wipe over the surface of your lawnmower with a dry cloth. transporting your Lawnmower Turn the fuel tap to the off position and transport with the engine in a horizontal position. Never transport the lawnmower when it is running. [. . . ] Your local approved Service Centre/Dealer will carry out any service or repairs required. Store your lawnmower in a cool, dry, damp-proof and safe place. Check that the choke control lever is in the correct position:- 'Run' position (N) - for a hot engine, 'Choke' position (L) - for a cold engine. Once the petrol has been replaced, it may take a little time for fresh petrol to filter through. [. . . ]