User manual FLYMO MULTITRIM 250D

[. . . ] FO T IN AN O RT e use ence I M P befor refer ure ead r fut R n fo retai & IO M AT R N For all customer enquiries or for replacement parts, contact:- 01325 300303 www. flymo. com eop. customer. services@electrolux. co. uk ¤ 1 Carton Contents Height Adjust Nut (if applicable) Handle Knob Steady Handle NonHeight Adjust Bolt Nut (if applicable) Handle Knob Bolt Steady Handle Guard Guard Instruction Manual Electric Cable with moulded on plug Electric Cable with moulded on plug Scraper Tool (Multi-Trim 200 only) Instruction Manual IMPORTANT !Please check the contents of the carton are correct BEFORE assembling your new Flymo product. IF ANY PARTS ARE MISSING CONTACT:Electrolux Outdoor Products Customer Service Department direct Telephone : 01325 300303, Fax : 01325 318193 Safety Please note: This manual covers various products. Please read the user instructions carefully to fully identify, assemble and use the features that apply to your trimmer. [. . . ] When initially switching on the trimmer, a small length of line is fed out. A `clattering' noise will be heard when the nylon line hits the line cutter. After approximately 5 seconds the line will be cut to the correct length and the noise will reduce as the motor reaches full speed. · Make sure the motor is up to full speed before trimming or edging. If the noise of the nylon line being cut cannot be heard, more line will need to be fed out. To feed more line, it is first necessary to to allow the motor to stop completely, then re-start, allowing the motor to reach full speed. until you hear the line hitting against the cutter. (Do not repeat this procedure more than 6 times) 6. If problems are experienced with the automatic line feed refer to Fault Finding Chart. J1 J2 Multi Trim 200 only line cutter wire guard line cutter 4 How to Trim and Edge WARNING: The use of eye protection is recommended. Do not lean over the trimmer whilst trimming or edging, objects may be thrown by the cutting line. Do not allow cutting head to rest on the ground. Overloading can be avoided by making sure the motor speed does not drop unduly. Disconnect from the mains electricity supply before attempting any maintenance or adjustment. BEFORE USE: Make sure that the line is fed out (if 2 lines are fitted, make sure both are fed out). Make sure motor is up to full speed before trimming or edging. Cut with nylon line at an angle using the tip. Swing trimmer in and out of the cutting area taking small cuts (M) 5. Line is fed out automatically every time the trimmer head stops rotating and returns to operating speed. · Extra line can be fed out manually as described on page 5. To stop your trimmer release the switch lever. To convert to edging mode, depress locking button and twist head anti-clockwise until arrow lines up with "EDGE". An audible "click" will confirm that the head is locked. [. . . ] Electrolux Outdoor Products Conforms to the specifications of Directive 2000/14/EEC I, the undersigned M. Bowden of Electrolux Outdoor Products, Aycliffe Industrial Park, NEWTON AYCLIFFE, Co. DL5 6UP Certify that a sample of the above product has been tested using directive 81/1051/EEC as a guide. The maximum Aweighted sound pressure level recorded at operator position under free field semi anechoic chamber conditions was :I, the undersigned M. [. . . ]