User manual FLYMO MULTITRIM CT250X

[. . . ] FO T IN AN nce O RT e use efere I M P befor ure r ead r fut R n fo retai & IO M AT R N 1 Carton Contents handle knob handle bolt Integrated battery charger wall bracket nut (if applicable) steady handle screws guard fixing plugs scraper tool shoulder harness instruction manual IMPORTANT !Please check the contents of the carton are correct BEFORE assembling your new Flymo product. IF ANY PARTS ARE MISSING CONTACT:Electrolux Outdoor Products Customer Service Department direct Telephone : 01325 300303 Fax : 01325 318193 Safety If not used properly this trimmer can be dangerous!This trimmer can cause serious injury to the operator and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this trimmer. [. . . ] This is normal and means the charger is operating correctly. Re-charge the battery as soon as the cutting power of your cordless trimmer begins to die and slow down. Avoid running the cordless trimmer into "deep" discharge, i. e. avoid flattening the battery completely. Follow the procedure outlined in the Initial Charging Procedure. Charging the battery according to these instructions should ensure maximum battery life. H 1 · The battery should be charged for 24 hours before use. · Re-charge your cordless trimmer immediately after every use for the full 24 hour charging period. · The cordless trimmer can be left connected to the charger permanently, with the charger switched on, without fear of overcharging. · The charger will automatically keep the battery topped up with charge during storage and will ensure that the cordless trimmer is ready for use. 4 Adjustment J To adjust the handle length (J & K) 1. (fig J) Adjust length of the handle to the most comfortable operating position (fig K). Re-tighten the height adjust knob. height adjust knob K 3. Auto Line Feed System 1. A short length of new line is fed out every time you switch on, this is caused by the cutting head accelerating up to its full speed. T feed more line, it is necessary to switch-off, allow the motor o to stop and then restart. When the line feeds you will hear a change in the motor sound as well as the noise generated by the line being cut to its length. If the line does not feed see Fault Finding Chart for further information. L line cutter How to trim and edge WARNING The use of eye protection is recommended. Do not lean over the trimmer whilst trimming or edging, objects may be thrown by the cutting line. Do not allow cutting head to rest on the ground. Overloading can be avoided by making sure the motor speed does not drop unduly. Disconnect from the mains electricity supply before attempting any maintenance or adjustment. BEFORE USE · Make sure that the line is fed out. · Make sure motor is up to full speed before trimming or edging. To start your trimmer · The switchbox is provided with a lock-off button (M1) to prevent accidental starting. To start, press lock-off button (M1), squeeze the switch lever (M2), release lock-off button. [. . . ] Electrolux Outdoor Products Conforms to the specifications of Directive 2000/14/EEC I, the undersigned M. Bowden of Electrolux Outdoor Products, Aycliffe Industrial Park, NEWTON AYCLIFFE, Co. DL5 6UP Certify that a sample of the above product has been tested using directive 81/1051/EEC as a guide. The maximum Aweighted sound pressure level recorded at operator position under free field semi anechoic chamber conditions was :I, the undersigned M. [. . . ]