User manual FLYMO PAC A MOW

[. . . ] Never pull on the cable to disconnect any of the plugs. Mains cables and extensions are available from your local Approved Service Centre. Avoid wearing loose-fitting clothing or that has hanging cords or ties. Obtain and wear safety glasses at all times. [. . . ] Do not use in the rain or leave the product outdoors while raining Never allow children or people unfamiliar with these instructions to use the product. Local regulations may restrict the age of the operator. Only use the product in the manner and for the functions described in these instructions. Never operate the product when you are tired, ill or under the influence of alcohol, drugs or medicine. The operator or user is responsible for accidents or hazards occurring to other people or their property. Important For a reliable and interference-free function of the machine, it is necessary to use a socket fused with 16 amps. If you are not sure, please let it be checked by an electrician. ) with a tripping current of not more than 30mA is Careful that pieces of metal, rocks, bottles, cans , ropes, netting or other foreign objects are not included. When feeding material into the product be extremely careful that the mains cable is not accidently fed into the product. Keep hands and feet away from the cutting means at all times and especially when switching on the motor. Do not touch the cutting means before the machine is disconnected from the supply and the cutting means have come to a complete stop. Clearing a Blockage The product is fitted with a reverse switch (J1) to enable the release of jammed material. Turn the control switch anti-clockwise to the symbol to put into reverse mode. Failure to do so may lead to serious damage to your product and result in your Warranty becoming void. Adjusting the Cutting Plate If branches and twigs are not being cut through cleanly, then adjustment of the Cutting Plate against the Cutting Blade is required. With the product running in the forward direction insert the hex key supplied into the hole at the side of the casing (L1). With the product running in the forward direction turn the hex key very slowly in a clockwise direction until the Cutting Blade (M1) can be heard slightly touching the Cutting Plate (M2) Do not over adjust, doing so could cause serious damage to the Cutting Plate and Cutting Blade and result in your Warranty becoming void. Feed a branch into the Feed Inlet to check that it is cut cleanly and that no further adjustment is required. Awareness of the environment must be considered when disposing of `end-of-life' product. If necessary, contact your local authority for disposal information. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. [. . . ] * This guarantee is additional to , and in no way diminishes the customers statutory rights. Failures due to the following are not covered, therefore it is important that you read the instructions contained in this Operator's Manual and understand how to operate and maintain your machine: Failures not covered by guarantee * Failures as a result of not reporting an initial fault. * Failures as a result of sudden impact. * Failures as a result of not using the product in accordance with the instructions and recommendations contained in this Operator's Manual. [. . . ]