User manual FLYMO SABRE SAW

[. . . ] Never operate the product when you are tired, ill or under the influence of alcohol, drugs or medicine. The operator or user is responsible for accidents or hazards occurring to other people or their property. Do not operate whilst people, especially children or pets are in the area. The use of safety glasses and a hard hat is recommended. [. . . ] 1) Grip product firmly with both hands when the motor is running. Use a firm grip with fingers and thumbs incircling the Sabre Saw handles 2) Do not over reach 3) Keep a proper footing and balance at all times 4) Do not let the nose of the guide bar contact a log, branch, ground or other obstructions 5) Use devices such as special guide bars that reduce the risks associated with kickback, as fitted to your product. 6) Only use replacement bars and chains specified by the manufacturer Maintenance and storage 1. Keep all nuts, bolts and screws tight to be sure the product is in safe working condition. Be careful during adjustment of the product to prevent entrapment of the fingers between moving blades and fixed parts of the machine. After use the product should be stored using the chain cover provided. Ensure that the Sabre Saw is switched off and disconnected from the Power Pack · Pull the cutting chain away from the guide bar. (P) The gap should measure approx 2-3mm 2. To adjust the tension, slightly loosen the hex socket head bolt (R) with the hexagon drive tool provided. Ensure that the Sabre Saw is switched off and disconnected from the Power Pack 1. Lubricate the whole of the cutting chain before each use, using the lubricating oil provided. Ensure that the Sabre Saw is switched off and disconnected from the Power Pack · Always wear gloves when removing or fitting the cutting chain. Use only a guide bar with bar tip designed for this product. In order to prevent kickback, do not remove the bar tip or replace the guide bar with one without a bar tip. Loosen the screws (K1) on the sprocket guard (K2) with a screwdriver and remove the sprocket guard. Loosen the hex socket head bolt (L1) with the hexagon drive tool provided and remove the bolt (L1) and spacer washer (L2). Push the guide bar (L3) against the tension adjusting spring (L4) and remove the guide bar and chain. Fit the chain over the guide bar with the bar tip upermost (M1), ensuring that the cutters are facing the revolving direction (M2) 2. Fit the chain over the sprocket (N1) and fit the concave end of the guide bar against the tension adjusting spring (N2). Insert the hex socket head bolt (L1) through the spacer washer (L2), and guide bar (L3) and tighten with the hexagon drive tool provided, ensuring the guide bar is secure. Fit the sprocket guard (K2) and tighten the screws (K1) ensuring the sprocket guard is secure. Ensure that the Sabre Saw is switched off and disconnected from the Power Pack · Always wear gloves when sharpening the cutting chain · sHARPEN THE CUTTING CHAIN TO THE SPECIFICATIONS ILLUSTRATED IN PICTURE T Filing the cutters 1. [. . . ] Failures due to the following are not covered, therefore it is important that you read the instructions contained in this Operator's Manual and understand how to operate and maintain your machine: Failures not covered by guarantee * Failures as a result of not reporting an initial fault. * Failures as a result of sudden impact. * Failures as a result of not using the product in accordance with the instructions and recommendations contained in this Operator's Manual. * Machines used for hire are not covered by this guarantee. [. . . ]