User manual FLYMO TC330

[. . . ] ® Turbo Compact Original Instructions FO T IN AN O RT e use ence I M P befor refer ure ead r fut R n fo retai & IO M AT R N Carton Contents start/stop levers upper handle cable clip lower handle washer bolt retaining clip nuts pin electric cable with moulded plug grassbox handle knobs switchbox grassbox lid washer bolt retaining clip cutting height spacers (1 fitted to lawnmower & 2 in loose parts pack spanner/scraper tool pin instruction manual IMPORTANT !Please check the contents of the carton are correct BEFORE assembling your new Flymo product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna UK Ltd. Customer Service Department direct Telephone : 0844 844 4558 Fax : 01325 302530 Safety If not used properly this lawnmower can be dangerous! [. . . ] The normal plug fuse and household fuse only protect the electrical equipment and are not a safeguard against electrocution. If your product is hard wired i. e. non-detachable mains electric cable, a conversion kit and extension cable is available from all Approved Service Centres which can be found in your local Yellow Pages. Assembly Instructions A B Handle slot C Grassbox lid assembly (A) 1. Fit one side of the grassbox lid as illustrated in Fig. Repeat for the other side. 1 2 Lower handle assembly (B) 1. Insert the lower handle into the handle slots, ensuring that the holes are aligned. Insert the pins and secure with the retaining clips. 3 Upper handle assembly (C) 1. Align the holes in the upper and lower handles and secure with the bolt, washer and wing knob. (C2) 3. Fit the cable to the handle with the clip provided. (C3) Make sure the cable is not trapped between the upper and lower handles. Starting and Stopping D E To Start your Lawnmower The Flymo Turbo Compact uses an advanced belt drive system, between the motor and the blade which improves cutting power and flotation in all conditions. Due to the high turning force (Torque) which this motor develops a light squeak may be heard when the machine is started, this is quite normal and will not effect the performance of the product 1. Connect female extension cable connector to the back of the switchbox. Form loop in mains cable and push the loop through the slot as illustrated in picture (E) 3. To secure, position loop over the hook and pull the cable back through the slot as illustrated in picture (F). To prevent a ring being cut in your lawn and to clear any residual grass in the collection chute, tilt your lawnmower slightly (G). F G Starting and Stopping cont'd H 1 The switchbox is provided with a lock-off button (H1) to prevent accidental starting. Press and hold the lock-off button (H) on the switchbox, then squeeze one of the Start/Stop levers towards the upper handle (J). Continue to squeeze the start/stop lever towards the upper handle and release the lock-off button. When the lawnmower has reached full speed gently lower it onto the lawn. NOTE: There are two start/stop levers fitted. Either one can be used for starting the lawnmower. IMPORTANT: Do not use the start/stop levers intermittently To Stop your Lawnmower 1. To prevent a ring being cut in your lawn and to clear any residual grass in the collection chute, tilt your lawnmower slightly (G). Release the pressure on the Start/Stop lever. J How to Mow 1. [. . . ] NOTE: Our Service Repairers act on their own behalf and are not empowered to commit or legally bind Husqvarna UK Ltd. in any manner whatsoever. Environmental Information Husqvarna UK Ltd. are manufactured under an Environmental Management System (ISO 14001) using, where practical, components manufactured in the most environmentally responsible manner, according to company procedures, and with the potential for recycling at the end of the products life. · Packaging is recyclable and plastic components have been labelled (where practical) for categorised recycling. [. . . ]