User manual FLYMO TORNADO 1600W

[. . . ] GB sure you understand them before using this unit. Retain these instructions for future reference. INSTRUCTION MANUAL IMPORTANT INFORMATION: Please read these instructions carefully and make FR atentivement les instructions et assurez-vous de les avoir comprises. Conservez les instructions pour référence ultérieure. MANUEL D'INSTRUCTIONS RENSEIGNEMENTS IMPORTANTS: Avant d'utiliser cet appareil, veuillez lire DE Geräts aufmerksam durch. Verwenden Sie es erst, wenn Sie sicher sind, daß Sie alle Anweisungen verstanden haben und gut aufbewahren. BETRIEBSANWEISUNG WICHTIGE INFORMATION: Lesen Sie diese Hinweise zur Handhabung des ES asegúrese de entenderlas antes de utilizar esta aparato. [. . . ] Then, press the two tubes together until the lower tube is securely seated in the upper tube (about 7, 6 cm). When vacuum tubes are fitted together, locate the label on the lower portion of the upper tube. Permanently assemble the two tubes together with the supplied screw. Upper Tube Screw Lower Tube Vacuum Inlet Cover (opened) 3. Turn the inlet restrictor counterclockwise and remove it from the unit. You will next attach the vacuum tubes. Vacuum Inlet Cover Align arrows on upper and lower tubes Inlet Restrictor Collection Bag Assembly 1. Open the zipper on the collection bag and insert the elbow tube. Push the small end of the elbow tube through the small opening in the bag. NOTE: Make sure edge of the small opening is flush against the flared area of the elbow tube and the hole for the tube release button is on top. 5 Elbow Tube Tube Release Button Hole Zipper Opening 3. Make sure the zipper is closed completely. Align the grooves on the elbow tube with the grooves on the blower outlet. Push the elbow tube onto the blower outlet until it snaps into place (elbow tube is secured by orange tube release button). Adjusting the shoulder strap on the collection bag 1. Carefully loop the shoulder strap through the buckle as shown in the illustration below. Last In First In Small Opening How to convert unit from vacuum use to blower use 1. Ensure unit is stopped and the mains electricity supply is disconnected. Remove the vacuum tubes by inserting the tip of a screwdriver into the latch area on the vacuum assist handle. Gently tilt handle of screwdriver toward the front of the unit to release the latch while pulling up on the vacuum assist handle with your other hand. Latch Area Vacuum Assist Handle 2. Position the unit on your right-hand side, blower outlet and bag pointing toward the rear. Hold the unit in an upright position with the lower vacuum tube on the ground to support it. Place the shoulder strap over your head and onto your left shoulder. Adjust the strap to allow a free flow of air from the blower. If the collection bag is kinked, the unit will not operate properly. NOTE: The strap is designed to position the collection bag on your shoulder without kinks. [. . . ] (h) The machine has not been used outside of the country for which it was specified. (i) The machine has not been used commercially. * This guarantee is additional to, and in no way diminishes the customers statutory rights. Failures due to the following are not covered, therefore it is important that you read the instructions contained in this Operator's Manual and under-stand how to operate and maintain your machine: Failures not covered by guarantee * Failures as a result of not reporting an initial fault. [. . . ]