User manual FLYMO VENTURER 320

[. . . ] FO T IN TA N ce P O R ore use feren I M bef re re ad futu Re for tain & re IO M AT R N For all customer enquiries or for replacement parts, contact:- 01325 300303 www. flymo. com eop. customer. services@electrolux. co. uk ¤ 1 Carton Contents start/stop lever cable clip nut (if applicable) lock off button upper handle plastic handle knob grassbox upper grassbox lower electric cable with moulded on plug spanner/scraper tool roller & rear height adjustment assembly (1 lever each side) instruction manual switchbox washer bolt lower handles safety flap lower handle fixing screws motor cover wheel assembly (x2) deck IMPORTANT !Please check the contents of the carton are correct BEFORE assembling your new Flymo product. IF ANY PARTS ARE MISSING CONTACT:Electrolux Outdoor Products Customer Service Department direct Telephone : 01325 300303 Fax : 01325 318193 Safety If not used properly this lawnmower can be dangerous!This lawnmower can cause serious injury to the operator and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this lawnmower. [. . . ] Ensure the upper handle is located correctly with the lock-off button on the switchbox uppermost. Ensure the upper handle and the lower handle are aligned correctly. (C) 3. Fit the bolts, washers and handle knobs. (C) 5. Fit the cable to the handles with the clips provided. Make sure the cable is not trapped between the upper and lower handles. Locate grassbox upper into grassbox lower. Align clips, ensure all clips are correctly located. Ensure all clips are securely connected. B C D 4 Cutting Height Adjustment Wheels - Front Cutting Height Adjustment · Height of cut is adjusted by raising or lowering the front wheels and rear roller. · NOTE The wheels and the roller must be adjusted to the same position: HEIGHT OF CUT WHEEL ROLLER Low Hole 1 Position H Medium Hole 2 Position J High Hole 3 Position K · NOTE A medium height of cut is recommended for most lawns. To remove the wheel assembly turn the wheel hub in an anti-clockwise direction. (E) 2. Select one of the 3 holes in the mounting plate and note it as the other wheel will need to be adjusted to the same position. (F) 3. Locate fixing bolt through hole in hub cap, wheel and selected hole in mounting plate. (F) 4. Turn the wheel hub in a clockwise direction until the wheel assembly is securely located to the deck. (E) 5. Using the same height adjustment position repeat the procedure for the other wheel. Roller and Rear Height Adjustment H - LOW J - MEDIUM K - HIGH 1. Select one of the 3 locations and note it as the other lever will need to be adjusted to the same position. Lift the lever out of location and rotate the roller to the desired position. Using the same height adjustment position repeat the procedure for the other lever. E to remove turn anti-clockwise to fit turn clockwise F mounting plate wheel hub cap 1 2 holes 3 fixing bolt G H J K Grassbox Fitting Fully Assembled Grassbox to Lawnmower. Make sure the discharge chute is clean and free from debris. Locate fully assembled grassbox onto 2 location points at the rear of the deck 4. Locate safety flap onto the top of the grassbox. Ensure the grassbox is securely located. [. . . ] DL5 6UP Certify that a sample of the above product has been tested using directive 81/1051/EEC as a guide. The maximum Aweighted sound pressure level recorded at operator position under free field semi anechoic chamber conditions was :I, the undersigned M. Bowden of Electrolux Outdoor Products, Aycliffe Industrial Park, NEWTON AYCLIFFE, Co. DL5 6UP Certify that a sample of the above product has been tested using ISO 5349 as a guide. [. . . ]