User manual FORD CROWN-VICTORIA-1996

[. . . ] Table of Contents Introductory Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Safety Restraints . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Starting Your Crown Victoria . . . . . . . . . . . . . . . . . . . . 37 Warning Lights and Gauges . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Press the left b side of the button to select the next listenable station down the frequency band. By holding the button down, listenable stations can be passed over to reach the desired station. u Using the "SCAN" function Pressing the "SCAN" button will begin the scan mode up the frequency band, stopping on each listenable station for approximately five seconds. To stop the scan mode on the presently sampled station, press the "SCAN" button again. u Setting the station MEMORY PRESET buttons Your radio is equipped with 6 station memory buttons. These buttons can be used to select up to 6 preset AM stations and 12 FM stations (6 in FM1 and 6 in FM2) Follow the easy steps below to set these buttons to the desired frequencies: 1. 152 Select a band, then select a frequency. 2. Press one of the memory buttons and hold the button until the sound returns. That station is now held in memory on that button. Follow the two steps above for each station memory preset button you want to set. 3. Using the Automatic Memory Store feature ("AUTOSET") If the memory buttons have been set, either by using the Auto Memory Load feature or if you have set them manually, the system is prepared to let you use a convenient feature called Automatic Memory Store. With Auto Memory Store, you can continually set strong stations into your memory buttons without losing your originally set stations. Your radio will automatically set your memory buttons to the strong local stations. Activate Auto Memory Store by pushing the "AUTOSET" button once. Your radio will set the first six strong stations of the band you are in (AM, FM1 or FM2) into the memory buttons. The display will flash "AUTO" and display the autoset icon "A" while the stations are being set in the memory buttons. NOTE: If there are fewer than six strong stations in the frequency band, the remaining unfilled buttons will store the last strong station detected on the band. After all stations have been filled, the radio will begin playing the station stored on memory button 1. To deactivate the Auto Memory Store mode and return to the manually-set memory button stations, simply push the "AUTOSET" button. Display will show "AUTO" then "OFF". The 153 next time Auto Memory Store is activated on that band, the radio will store the next set of six strong stations. Adjusting the tone balance of your radio u Increasing or decreasing bass and treble response Push the "BASS/TREB" popout knob to gain access to the bass and treble controls. Bass control allows you to adjust the lower, bass frequencies to your preference. The outer ring of the "BASS/TREB" knob adjusts the bass (turn clockwise to increase bass; counterclockwise to decrease bass). Treble control allows you to adjust the higher, treble frequencies of your radio to your preference. The inner ring of the "BASS/TREB" knob adjusts the treble (turn clockwise to increase treble; counterclockwise to decrease treble). u Adjusting speaker balance and speaker fader Push the "BAL/FADE" popout knob to gain access to the speaker balance and fader controls. Balance control allows you to adjust the sound distribution between the right and left speakers. [. . . ] Restraints, safety (see Safety restraints) adult. 149 184 140 101 291 271 146 129 129 130 131 130 . . Safety restraints adjusting the safety belts. automatic locking mode (retractor) cleaning the safety belts . [. . . ]